FAITHFULL FPP DH240V30L Industrial Dehumidifier Instruction Manual
- June 15, 2024
- FAITHFULL
Table of Contents
FAITHFULLY **FPP DH240V30L Industrial Dehumidifier Instruction Manual
**
Industrial Dehumidifier
Instructions
INTRODUCTION
The Fathfall Industrial Dehumidifier moisture from humid air to limit mould, mines and condensation. This powerful unt can extract up to 30 Bores of water per day to create a healthier . Easy in open ale much past with an LCD meen that delays temperature and humidity and andicates when the tank is fu. A 24 tour timer faction allows automatic start and stop smes to be set. An automatic defrost function wit activate if the room temperature dropa too low. The unit will automatically shut off when the 7 kire tank is full An optional continuous drainage function can direct matter to a drain or suitable receptacle with the 1M pipe provided, Durable metal hovasing with heavy-duty whods for easy maneuverability.
IMPORTANT SAFETY INFORMATION
Carefully read the instructions before operating the unit.
- This appliance is for indoor use only. Any other use is not recommended by the manufacturer and may cause fire, electrical shocks or other injury to user or property.
- This appliance can be used by children aged from 8 years and persons with reduced capabilities if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- Rating : This unit must be only connected to a 220-240 V / 50 Hz earthed outlet.
- Avoid touching any moving parts of the appliance.
- Never insert fingers, pencils or any other objects though the guard.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities. It is also not intended for use by those with a lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
- Never operate this appliance if the cord, power adapter or plug is damaged. Ensure the power cord is not stretched or exposed to sharp objects/edges.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
- Children should not play with the appliance.
- Any service other than regular cleaning or filter replacement should be performed by an authorized service representative. Failure to comply could result in a voided warranty.
- Do not use the appliance for any purpose other than its intended use.
- Always place the unit on a dry and stable surface.
- Do not use means to accelerate the defrosting process or to clean, other than those recommended by the manufacturer.
- The appliance should not be stored in a room with ignition sources (for example: open flames, an operating gas appliance or an operating electric heater)
- Do not pierce or burn,
- Be aware that refrigerants may not contain an odour.
Tools required for assembly
ASSEMBLY ”
Note: After installation, the machine must be kept upright for 2 hours before plugging in.
ATTACHING THE HANDLE
- Unscrew the two bolts at top of the body.
- Lift the handle upright and fix in place in with the bolts removed in the previous step.
PRODUCT OVERVIEW
DRAINAGE OPTIONS
Water Tank
The dehumidifier has a removable water tank. When the water tank, is the
machine automatically shuts down and enters the standby state, the LED
displays the “Full Water signal and the buzzer sounds. When the water tank la
emptiled and put back into place the dehumidifier can continue its operation.
Continuous Drainage
To achieve continuous drainage you need to take out the water tank remove the
plug, and install the drain pipe. Put the water tank back to its original
position, and the water pipe goes out through the side plate.
Tip : In continuous drainage, the drainage pipe shall not be set higher than the water tank.
CONTROL PANEL
(A) Timer
(B)Temperature
(C) Dehumidifiaction
(D) Humidity
(E) Power
(F) Timer set
(G) Minus
(H) Plus
(I) Water Tank Ful
(J) Air Speed
(K) Defrost
FUNCTIONS
Humidity Control When the room humidity reaches the desired setting, the
compressor and fan will shut down and when it’s higher than the humidity value
set, both fan and compressor operate.
Note
- When the hurmidity is set at the minimum value, it’s defaulted to enter the continuous dehumidifying mode.
- When the machine shuts down, the fan will stop 10s later.
Defrost Mode
The unit enters Defrost Mode after 20 mins if the coil temperature is -1°C or
lower. In Defrost mode, the compressor stops but the fan continues to run and
the Defrost light turns on.
Note
- Defrost mode ends when the coll temperature is greater than 7°C for 8 mins.
- When its finished the fan and compressor will both resume.
Timer Function
When the unit is powered on, you can set timer to power off, and when it’s
powered off, you can set timer for powering on, Setting the timer for both
powering on and off then initiates the cycle fimer mode.
A, Set timer for powering on : When it’s powered off, press the “Timer” Button, Press or to adjust the Timer. The buzzer makes a sound once the button is pressed. Holding the button constantly for 2s can continually increase or decrease the time. Leave for 10s once adjusted to the required value, the dehumidifier accepts the new setting and the “Timer On icon flickers.
B. Set timer for powering off : When it’s powered on, press the Timer Button. Press” or to adjust the Timer. The buzzer makes a sound once the button is pressed. Holding the button constantly for 2s can continually increase or decrease the time, Leave for 10s once adjusted to the required value, the dehumidifier accepts the new setting and the “Timer Off icon flickers.
PROTECTION
- Once shut down, the compressor takes 3 mins to restart. Quick start is available for the first power-on.
- Power off memory: For abrupt power outage or accidental unplugging of the plug, the system will automatically archive the operating state right before the incident, and continue at that state for the next power-on.
- Full water protection: When the water tank is full, the dehumidifier automatically shuts down and enters the standby state, the indicator light “Full Water turns on and buzzer sounds.
USER INFORMATION
- The humidity sensor may not function properly in an environment where corrosive gas or heavy dust are present.
- Do not use in an enviroment where combustible gas, chemicals or biological products are present. Damage caused to the dehumidifier by use in said environment will invalidate the warranty.
- Water may be discharged from the machine after a period of time check water level throught use.
- To minimize faults and maximize the lifetime of the machine, press the buttons in a gentle manner.
- The deviation between the humidity shown on the sensor and the actual humidity is normal, due to impact by the location, environment and temperature.
- It is normal for hot to be discharged from the outlet.
- The higher the temperature and humidity of the environment, normally the greater the dehumidifying effect, while the lower the temperature and humidity of the environment, typically the lower the dehumidifying effect.
- It is normal to hear the sound of the circulation of refrigerant when the dehumidifier runs.
PRECAUTIONS
Do not attempt to repair this
appliance yourself.
Do not use this appliance in direct sunlight.
Keep out of the way of children when in use.
Do not place this appliance beside a heat source such as a stove or heater.
Do not use this appliance near
water.
Unplug the machine before
cleaning.
TROUBLESHOOTING
Upon fault of the dehumidifier, please cut off the power supply
immediately, unplug the plug and check the following items:
| FAULT | CAUSE | SOLUTION |
|---|
Failure to
operate (Stow.as m.o.:0| Power outage or broken
socket| Cheek power supply
works
Is it plugged in correctly?| Plug into socket
Fuse blown| Replace fuse
Failure to
operateCaws, as mote cal| Room humidity is lower
than set value| Reset the value
Is it water tank in
correctly?| Place water tank In
detect position
Is defrosting mode on?| Wait for defrost to finish
Unit not
waking
ProPeflY| Obstmcbro in the air
inlet/outlet| Remove obstruction
Is the door or window
open?| Close the door and
window
Room temperature’s too
low.| Do not use the
Dehumidifier
Unit is too
noisy| Ground is uneven or knit
is not level| Make sure the unit is level
and on a fine surface
Unit is not level| Make sure the unit is level
and on a firm surface
Water leakage| Drain obspipetructed/outlet Is| Remove obstruction
| ERROR | CAUSE | SOLUTION |
|---|---|---|
| El | Coil fault | Contact the manufacturer |
| E2/E3 | Humidity and and | |
| temperature sensor fault | Unplug the unit, rest and |
plug it back in. If error repeats.
call service centre
EE| Refrigerant leak| Turn Machine off and
contact manufactuer
HI| Ambient temperature is
above 38°C| Wait for ambient
temperature to decrease
LOW| Ambient temperature is
below-3°C| Wait for ambient
temperature to increase
If the above methods stil ail to eliminate the troubles, please directly
contact the manufacturer.
Do not attempt to disassemble o repair the dehumidifier yourself.
TECHNICAL SPECS
| Model | BGD2304-30-X |
|---|
Ma Ian Removal
Capacity| 301.1cl9y(30t RH80%)
201.lday(27t RH60%)
Power Supply| AC220-240W5Calx
Rated POMet| 650W(30T RH80%)
550W(2PC FIH60%)
Razed Conant| 10A(30•C RH80%)
2.41(27t RW20%)
Max Suction Pressure| 1.0MPa
Max Ceicharge Pressure| 2.5MPa
Refrigerael| R2900200
minute Fraction| P22
Not Weight| 22kg
Produel Size| 414 x 336 x1350 mm
IMPORTANT SAFETY INFORMATION
Itis essential that you read and understand the instructions contained in this
manual before using the product for the first time. Failure to follow these
instructions could result in personal injury or possible damage to the
product. This manual should be stored safely for future reference.
DISPOSAL OF THIS PRODUCT
Dear Customer, If you at some point intend to dispose of this product, then
please keep in mind that many of its components consist of valuable materials,
which can be recycled.
Please do not dispose of this product it in the household waste bin, but check
with your local council for recycling facilities in your area.
FATHULL TOOLS
3 White Lodge Business Estate, Hall Road, Norwich, Norfolk, NR4 6DG, United
Kingdom
TUCKS O’BRIEN LTD
24 Magna Drive, Magna Business Park, Citywest Road, Dublin 24, D24 FNYO,
Ireland.
E-mail:
enquiries@faithfulltools.com