VEVOR XF-E004A-2 Adjustable Support Pole User Manual
- June 15, 2024
- VEVOR
Table of Contents
VEVOR XF-E004A-2 Adjustable Support Pole User Manual
www.vevor.com/support
We continue to be committed to provide you tools with competitive price. “Save
Half”, “Half Price” or any other similar expressions used by us only
represents an estimate of savings you might benefit from buying certain tools
with us compared to the major top brands and doses not necessarily mean to
cover all categories of tools offered by us. You are kindly reminded to verify
carefully when you are placing an order with us if you are actually saving
half in comparison with the top major brands.
NEED HELP? CONTACT US!
Have product questions? Need technical support? Please feel free to
contact us: CustomerService@vevor.com
This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won’t inform you again if there are any technology or software updates on our product.
GENERAL SAFETY RULES
⚠ WARNING: Read and understand all instructions. Failure to follow all
instructions listed below may result in serious injury.
Various dangers may occur if the hand lever grease gun is improperly handled
during installation, commissioning and daily operation.
Risk of injury and damage to material property because of improper handling. Hold the manual at the disposal of the operating staff at the usage site of the unit. Country-specific safety measures and accident prevention regulations must be observed.
Persons are qualified if they are, due to their training, experience,
instruction and knowledge of the relevant standards, able to assess assigned
tasks and to identify potentially hazardous situations.
It is strictly prohibited to use the support rod for overload.
CAUTION: Defective accessories can lead to personal injury and material
damage. During their period of use, accessories must be checked for
wear,cracks, and other damage. Defective accessories should be replaced
immediately.
SAVE THESE INSTRUCTIONS.
MODEL AND PARAMETERS
STRUCTURE DIAGRAM
- Adjusting lever
- Release Button
- Adjusting lever
- Micro Adjustment Handle
- Knob
- Support Rod
- Non-slip Pad
COMPONENTS
OPERATING INSTRUCTIONS
Operation Preparation:
- Please prepare gloves to avoid being scratched by sharp parts that may occur during installation.
- Please open all the boxes to check that the accessories are complete and in good condition.
Operation:
Step 1 Buckle the support feet into both ends of the support rod, as shown
Step 2 Multiple support rods can be selected according to the working
scenario, as shown in the following figure.
Support rod adjustment operation:
-
Loosen the knob to extend or shorten the rod and then tighten the knob.
-
Press the handle to fine-tune the rod until it is fixed.
3) End of use and lift the release button to put
away the rod.
Step 3 The support rod can also be used at any Angle, as shown below
Fully rotating head
MAINTENANCE
- Before each use, inspect general condition of support rod. Check for cracked or damaged parts, misaligned or bending of moving parts, and any other condition that may affect product’s safe operation. If a problem occurs, have the problem corrected before further use. Do not use damaged product.
- Do not overload.
- After use, please clean up before storage to avoid rusting of bolts affecting use.
- Check the knob regularly for damage.
VEVOR STORE INC 9448 RINCHMOND PL #E RANCHO CUCAMONGA, California, 91730 United States of America Made in China
Technical Support and E-Warranty Certificate www.vevor.com/support
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>