DOMETIC 400 Series Corp Control Cable Installation Guide
- June 15, 2024
- Dometic
Table of Contents
Casing Guide
Attachment to type 400 cables
INSTALLATION INSTRUCTIONS
Copy Part# IS-15365, Rev. 2
Date: 03/2023
400 Series Corp Control Cable
NOTICE!
Installer : These instructions contain important safety information and
must be forwarded to the boat owner.
The ends of the core wire in this control have been annealed and must be
installed strictly in accordance with the following Instructions.
To secure the control wire in the casing guide, the control wire is held
securely in place by two screws, the clamp screw and the anchor screw—but the
wire must be kinked to ensure positive location. This is easily done by first
turning the clamp screw until it just touches the wire.
Next advance the clamp screw one turn only. This will kink the wire
sufficiently to locate it in the casing guide. Finally, install the anchor
screw and tighten securely. See figure 1.
CAUTION!
It is possible to completely shear off the wire, so be careful to advance the
clamp screw to the point of contact only and then make just one complete turn
to kink the wire without shearing it.
Figure 1. Casing guide (motor end, control end similar).
WARNING!
When assembling the casing guides, secure anchoring of the control wires is
extremely important. The wires must be properly secured or they may come loose
during operation of the engine. Following the procedure outlined above will
ensure a safe installation.
YOUR LOCAL DEALER
dometic.com/dealer
YOUR LOCAL SUPPORT
dometic.com/contact
YOUR LOCAL SALES OFFICE
dometic.com/sales-offices
A complete list of Dometic companies, which comprise the
Dometic Group, can be found in the public filings of:
DOMETIC GROUP AB
DOMETIC GROUP AB Hemvärnsgatan 15 SE-17154 Solna Sweden
4445104010
IS-15365 2023-03-07
Documents / Resources
|
DOMETIC 400 Series Corp Control
Cable
[pdf] Installation Guide
400 Series Corp Control Cable, 400 Series, Corp Control Cable, Control Cable,
Cable
---|---