Hanwha Vision SHD-3000F2 In Ceiling Housing Instruction Manual

In-ceiling Housing
Installation Manual
SHD-3000F2

OVERVIEW

This In-CEILING HOUSING is a mounting ADAPTOR that is designed to mount the smart dome camera in built-in style on a double-layer ceiling.

WHAT’S INCLUDED

INSTALLATION INSTRUCTIONS

1. Select an installation position or place that can endure more than 4 times of the total weight of the installation structure.
2. At least 250mm or more of spare height is required above the CEILING BOARD.
3. CEILING BOARD’s thickness should be less than 40mm.
4. Be sure to secure the SAFETY WIRE to avoid a product fall.
5. If you want to attach the camera to the ADAPTOR, use the only provided SCREWS.

INSTALLATION (INDOOR TYPE)

1. Place the TEMPLATE on the CEILING BOARD and drill a guided hole.
   ❶ Remove the round filling (“C”) from the TEMPLATE.
   ➋ Place TEMPLATE A onto the CEILING BOARD to which you will attach the ceiling mount ADAPTOR and drill a hole of Ø165mm in diameter.
   See the figure below for the hole shape.

2. Fix the ANCHOR BOLT onto the concrete CEILING, and secure the SAFETY WIRE to the ANCHOR BOLT as below:
   ❶ Tighten the nut (“N1”) on the ANCHOR BOLT.
   ➋ Insert the provided SAFETY BRACKET into the ANCHOR BOLT.
   ➌ Tighten two nuts (“N2”,”N3”) onto the ANCHOR BOLT.
   ➍ Hook and fix one end of the SAFETY WIRE onto the SAFETY BRACKET.
   ➎ Hook and fix the other end of SAFETY WIRE onto the HOUSING as shown below.The ANCHOR BOLTs and nuts are optional and not included in the product package.

3. To connect to the camera, insert the external cable through the side hole on the housing to the inside of the housing as shown in the figure.
   Refer to the installation manual of the camera that you want to install, and prepare necessary cables for camera connection.

4. Push the HOUSING inside the CEILING through the CEILING hole, and tighten the SCREWs (x2) clockwise to fix the HOUSING on the CEILING.
   (The BRACKET will be positioned from to as shown.)
   Ensure that the HOUSING is firmly secured to the CEILING BOARD.

5. Remove the dome cover from the camera

6. Installing the camera
   Using the three screws, mount the camera in the housing.
   ※ When attaching the camera to the mount, check the arrow directions in the figure below before proceeding.

7. Install the cover onto the HOUSING.Assemble the network cable through the hole on the bottom part of the housing.