KATVR Coord 2 Vehicle Hub User Guide
- June 13, 2024
- KATVR
Table of Contents
KATVR Coord 2 Vehicle Hub User Guide
The Vehicle Hub can only be used with KAT Walk Coord 2, and other
application is prohibited.
Rubber cover: If needed, you may install it to protect the surface from
scratches.
Small differences may occur depending on the device version.
Installation Guide
-
Remove the hole plugs from the supporting rods.
-
Insert the bolts of the inner mounting plates into the rod holes from inside out. Then, align the openings of the outer mounting with the bolts and tightly fasten with a hexagon key.
-
Push the cover down to open it and install 2 AA batteries.
*According to different versions:
Standard can be opened normally; A reinforced version requires to first remove an extra screw holding the cover.
-
Take out the receiver and plug it into the computer. Pair the sensor (follow the instructions in KAT Gateway).
-
Pairing Button: Press the button for 3 seconds to complete the paring. indicator light：Blinking light – pairing. Continuous light – pairing completed.
-
Installation complete! Open the sitting posture system as shown above and enjoy your adventures with the KAT Vehicle Hub!
User Guide
-
Grab the seat rods and pull them down to unfold the seat module.
-
It automatically retracts when you stand up.
-
Seat module button: Vehicle Mode can be quickly turned on and off through the seat module button.
Do not install it on other objects. Once installed on the C2+, do not remove.
Detailed information available in the user manual. KAT Vehicle Hub User
Manual available here:
https: //www.kat-vr.com/pages/support
Before using the device in games, read carefully and follow the instructions of the KAT Vehicle Hub User Manual.
Contact: service@katvr.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>