milwawkee 3702-21 Receiver Remote User Guide
- June 15, 2024
- milwawkee
Table of Contents
milwawkee 3702-21 Receiver Remote
GET STARTED – LASER
POWER
Press to turn ON, and press and hold to turn OFF.
PAIRING
Used to pair the laser with the receiver/remote. The laser and receiver/remote
kit will already be paired. To pair the laser and receiver/remote, select the
PAIRING feature in the menu on the receiver/ remote then press and hold the
PAIR button on the laser. When paired, the pairing icon will show in the
receiver/remote’s status bar
BUMP SENSITIVITY
Laser defaults to High Sensitivity. The setting can be switched to Low Sensitivity with a paired receiver/remote.
RPM
Select the desired RPM between 300, 600 and 1,200.
SWEEP
Different sweep angles can be selected between 10°, 45°, 90° and dot mode.
LEVEL
Indicates the levelling mode the laser is currently in.
RECEIVER/REMOTE MENU NAVIGATION
BUTTON LAYOUT
POWER
Press to turn ON, and press and hold to turn OFF.
CENTER FIND
Initiates centre find sequence
FEATURES
CENTER FIND
The laser automatically searches and aligns with the centre of the
receiver/remote. Pressing the Center Find button on the receiver/remote or
selecting “Center Find” in the menu allows the laser to search for and find
the centre of the receiver/remote. Once the centre is found, the
receiver/remote will emit a solid tone and then revert to normal readout.
ALIGNMENT
Manually align or slope the laser line with the receiver/remote’s D-PAD.
Use the D-PAD to move the laser up or down along the Y axis, or move it left
or right when the laser is in vertical orientation. To reset back to level,
Press the LEFT & RIGHT on the D-PAD simultaneously.
MASK
Use the D-PAD to mask desired quadrants where the laser will be hidden. Note:
Only adjacent quadrants can be masked. Only 3 total quadrants can be masked at
any time.
RPM
Select the desired RPM between 300, 600 and 1,200.
OFFSET
Set a new centre position on the receiver/remote for the laser by adjusting
the receiver/remote to the desired offset and pressing OK. The receiver/remote
readout will now show the desired offset distance from the centre. Exit out of
offset to gain a regular readout utilizing the newly adjusted centre. To
revert to the original centre line as the target for the laser, enter offset
and press LEFT & RIGHT on the D-PAD simultaneously
CHANNEL LINK
Channel Link can be used to eliminate interruptions from other lasers by distinguishing and detecting only the preferred laser. Selecting a channel will update the receiver/remote setting as well as update the setting on any paired laser. CH– is the universal channel and will detect any lasers in that default channel. While the receiver/remote is in CH 1,2,3 it will only detect lasers in matching channels.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>