REGIN TG-AH4 Clamp On Sensor Instructions
- June 15, 2024
- REGIN
Table of Contents
INSTRUCTION
TG-AH4
IN20066 REV. A, 2021-07-06
Caution! Read and understand the instruction before using the product.
Caution! Ensure that the installation complies with local safety
regulations.
Function
The clamp-on sensor measures the media temperature in pipes. Several models with different sensor elements are available, making it possible to use these sensors together with different controller brands.
Technical Data
| Protection class | IP42 |
|---|---|
| Time constant | 3 s |
| Measuring range, temperature | -20…+120 °C |
| Cable gland | M16 |
| Dimensions, external (WxHxD) | 104 x 78 x 51 mm |
| Accessories, included | One metal strap and heat-conductive paste (art.nr: |
PASTA-20)
Installation
The installation is done by following these steps:
- Twist the cover counter-clockwise to access the terminals.
- Spread heat-conductive paste on the metal surface that will be in contact with the pipe.
- Place the sensor according to Figure 1 and use the metal strap to fasten it around the pipe.
- Use the dedicated screw to secure the metal strip as shown in Figure 2.
- Ensure that the metal strip does not stick out from the housing. Cut it if necessary.
- Connect the wires from an analog input of a controller to the terminal block.
- Screw the cover back on.
**** This product carries the CE-mark. More information is available at www.regincontrols.com.
Contact
AB Regin, Box 116, 428 22 Kållered, Sweden
Tel: +46 31 720 02 00, Fax: +46 31 720 02 50
www.regincontrols.com,
info@regincontrols.com
TG-AH4
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>