SWEBAD VISBY 140 Corner Bathtub Installation Guide

Table of Contents

SWEBAD VISBY 140 Corner Bathtub PRODUCT

MÅTT: 139 x 139 x 68 cm VOLYM: 280 l.

SWEBAD VISBY 140 Corner Bathtub 01

Length of the power cable min. 2 m. Thickness of cable and number of cores depends on performance of the device and should meet the local requirements. Connections must be made by an authorised electrician.
Closable cold and hot water input G ½.
Sewage opening D = 50 mm

SWEBAD VISBY 140 Corner Bathtub 02

All electrical connections related to the installation of the product must be executed by a certified professional electrician.
At connecting, all local regulations must be observed as well as permissible load on one phase. To achieve local auxiliary equipotential bonding, make sure you connect all conductive objects in the same room with the earthing terminal of the product’s aluminium frame:
The cross-section of the copper earth continuity connector must be a minimum of 2.5 sq. mm.
The power circuit of the product must be protected with a residual current circuit breaker with 30mA threshold and a circuit breaker the operating current of which is levelled with the consumed current of the product. The product is connected to the electrical power line as a stationary device, with no plug connector.
The length of the power line should allow moving the product away from walls if necessary. Options for connecting to the power network according to local opportunities are given on the diagrams below.

MÅTT: 149 x 149 x 68 cm VOLYM: 330 l.

SWEBAD VISBY 140 Corner Bathtub 04

Length of the power cable min. 2 m. Thickness of cable and number of cores depends on performance of the device and should meet the local requirements. Connections must be made by an authorised electrician.
Closable cold and hot water input G ½.
Sewage opening D = 50 mm

SWEBAD VISBY 140 Corner Bathtub 05

All electrical connections related to the installation of the product must be executed by a certified professional electrician.
At connecting, all local regulations must be observed as well as permissible load on one phase. To achieve local auxiliary equipotential bonding, make sure you connect all conductive objects in the same room with the earthing terminal of the product’s aluminium frame:
The cross-section of the copper earth continuity connector must be a minimum of 2.5 sq. mm.
The power circuit of the product must be protected with a residual current circuit breaker with 30mA threshold and a circuit breaker the operating current of which is levelled with the consumed current of the product. The product is connected to the electrical power line as a stationary device, with no plug connector.
The length of the power line should allow moving the product away from walls if necessary. Options for connecting to the power network according to local opportunities are given on the diagrams below.