SCANDTAP 46251 Bathroom Cabinet Instructions
- June 4, 2024
- SCANDTAP
Table of Contents
SCANDTAP 46251 Bathroom Cabinet
TOOLS
-
Components and tools
-
Recommended height (adapt to the height of the free-standing basin). *Small tolerances in dimensions may occur since the product is hand made. Always control measure the locations of the holes in the wall.
-
If needed, drill a hole for a basin mixer in the grey zone B, and for washbasin in the grey zone D. See the table for dimensions.
-
Space for pop-up and bottle trap.
-
Lift out the drawer.
-
Use a spirit level to ensure the cabinet is straight. Control measure and mark up the positions for screw holes.
-
Correct method for installing screws into walls. A: wooden studs. B: concrete.
-
Push the cabinet over the bolts, with the white padding mat between the cabinet and the wall. Then install washers and nuts over each bolt according to the picture.
-
Reinsert the drawer. Place the non-slip mat in the drawer.
-
Clean with a sponge or the included polishing pad.
-
If the resistance of the drawer is too high, it can be calibrated according to the picture.
-
Recommended position for in-drawer outlet (not included).
Maintenance Solid Surface
Avoid that the material comes into contact with the following:
- Acetone
- Acids and cleaning agents that contain Chloromethane
- Petroleum-based cleaning agents
- Solvents, Thinner
- Drain cleaners
- H2O >70°C
Also avoid that the surface of the basin comes into contact with coloured substances such as cosmetics for longer durations. In case of such contact, rinse with lukewarm water and, if necessary, soap.
Cleaning:
Clean the surface regularly with a soft cloth and lukewarm water. If
necessary, use soap. Afterwards, rinse with clean water and then dry the basin
with a soft cloth.
In case of scratches or discolorations:
Scratches and discolorations can under normal circumstances be removed simply
by polishing the affected surface with a sanding pad/sandpaper with a grade of
P800-P1000.*
- Start by cleaning the the surface with a soft cloth and a mildly abrasive cleaning agent.
- Rinse with clean water and dry with a soft cloth.
- If the scratch or discoloration remain, apply a sanding pad/sandpaper with a grade between P800-P1000 on the affected area and polish with even circular movements.
- In case of deeper scratches, it may be necessary to first polish the surface with a rougher grade of sanding pad/sandpaper, and then switch to increasingly finer grades. Start with P240, then switch to P400 and finally P800-P1000. 5. Lastly, repeat step 1–2 for final polishing.
Sanding pad is available from Scandtap with article number 81001. For more information,visit scandtap.com.
If you have any other question, please contact your retailer or visit www.scandtap.com
Scandtap AB, Olofsdalsvägen 21, 302 41 Halmstad, Sweden+46 35 260 75 80, info@scandtap.com, www.scandtap.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>