ZMIRNE H08 PTC Ceramic Space Heater User Guide

ZMIRNE H08 PTC Ceramic Space Heater

IMPORTANT SAFETY INSTRUCTIONS

Thank you for choosing The PTC Ceramic Space Heater.
Please read this User Guide thoroughly before use and keep it for future reference.

IMPORTANT SAFETY INSTRUCTIONS

FOR HOUSEHOLD USE ONLY

WARNING Read all safety instructions before using this heater. Use this heater only as described in this manual.
Failure to follow all of the instructions listed below may result in electric shock, fire and/or serious personal injury.

GENERAL SAFETY

1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
3. Use the handle to move this heater.
4. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operatingand unattended.
5. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
6. The output of this heater may vary and its temperature may become hot enough to burn exposed skin. Use of this heater is not recommended for per:sons with a high sensitivity to heat or an inability to react to avoid burns.
7. Do not attempt to modify or repair the product by yourself Doing so could void the warranty and cause damage or personal injury.Only a repair technician may disassemble or repair this product
8. Make sure that no pieces of polystyrene or other packaging material have been left between elementsof the appliance. It may be necessary to pass over theappliance with a vacuum cleaner.
9. lf the machine is not working as it should, has received a sharp blow,has been dropped, damaged,left outdoors,or dropped into water, do not use and contact Customer Support.
10. There may be a trace of smoke or odor when the unit is first operated. This indicates that a drop of oil fell on the heating coil during the manufacturing process. It will quickly evaporate and should not re-occur.

LOCATION SAFETY

1. Do not use outdoors.
2. Ensure the heater is on a stable, secure surface to eliminate the potential of tipping it over.
3. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least3 feet (0.9m) from the front of the heater and keep them awayfromthe sides and rear.
4. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
5. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed,where openings may become blocked.
6. This heater is not intended for use in bathrooms,laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.

ELECTRICITY SAFETY

1. Always unplug heater when not in use.
2. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair.
3. Do not run cord under the carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
4.  To disconnect heater, turn controls to off, then remove plug from outlet
5. Always plug heaters directly into a wall outlet/receptacle.
6. Never use with an extension cord or relocatable power tap (outlet/power strip).
7. If there is a loose fit between the plug and the socket or the plug becomes very hot, the socket may need to be replaced.Check with a qualified electrician to replace the socket.
8. lt is normal forthe plug and cord to feel warm to the touch.
9. A plug or cord which becomes hot to the touch or becomes distorted in shape may be a result of a worn electrical outlet.Worn outlets or receptacles should be replaced prior to further use of the heater.Plugging the heater intoa worn outlet /receptacle may result in overheating of thepower cord orfire.
10. This appliance has a polarized plug (one prong is wider than the other). To reduce the risk of electric shock,this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug . If it still does not fit, contacta qualified electrician.Do not attempt to rig this safety feature.
    DANGER – High temperatures may be generated under certain abnormal conditions. Do not partially or fully cover or obstruct the front of this heater.
    READ AND SAVE THESE INSTRUCTIONS

PRODUCT INTRODUCTION

SPECIFICATIONS

• Model AR-HOS
• Rated Power 1500W
• Input 110—-120V

LED Display

Control Panel

Remote control

More Features
The display shows the real-time ambient temperature, and the temperature control module has double overheat protection

• Memory Function
  The heater will remember its last settings (temperatures, working mode) once turned on again.

• Tip-Over Protection
  When the heater is tipped over,it will beep the alarm “di,di,di”

• Overheat Protection
  When the heater overheats, it wills hut off automatically with the error code “h h” on the display.

• 24-Hour Auto Off
  When the heater has been running for24 hours without any operation, it will shut off automatically.

CLEANING AND MAINTENANCE

• Always tum off and unplug before cleaning.

• Outer Surface
  Use a soft, dry cloth to gently wipe clean the outer surface.

FILTER Mesh

TIP: For best performance, please clean the filter mesh every 2-4 weeks.

Air Inlet
Use a soft, dry cloth or a cotton-tipped swab to remove any dust from the air inlet.

ATTENTION

TROUBLESHOOTING

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>