THE HOME DEPOT R352HG Metal Garden Obelisk Trellis Installation Guide
- June 4, 2024
- THE HOME DEPOT
Table of Contents
THE HOME DEPOT R352HG Metal Garden Obelisk Trellis
Components
- Legs 8
- Top curved tubes 2
- Hole maker indication 18 in. depth 1
- Tubular rings 3
- Joint/moisture protection sleeve 8
- 11/8 in. black bolts 12
- Self tapping finial screw 1
- Instruction sheet 1
Assembly
Helpful hints:
You may find it easier to assemble your obelisk horizontally on its side and
then carefully stand it upright to install Before assembling the obelisk, use
one of the plastic rings as a template to mark
out the 3 leg positions in the desired location. This will aid fitting.
Soaking the moisture protection sleeves in warm water for a few minutes prior
to fitting will make them more malleable and will aid fitting.
- Fit the upper leg tubes (A) to lower leg tubes (B) with the moisture protection sleeves (D). Slide the moisture protection sleeves half way onto the joint of the upper leg tubes before pushing the lower leg tubes into the sleeves and joint.
- Place finial (G) on top of the leg assemblies, insert screw (F) through the top of the three flattened leg assemblies and into the base of the finial. Tighten screw.
- Connect all three leg assemblies by clipping them inside the 3 plastic rings (C). For best results the rings should be spaced approximately 0.30m (1) apart.
- Place assembled obelisk in desired location and mark the leg positions on the ground. Remove obelisk and drive hole maker (E) to a recommended depth of approximately 0.30m (1). Insert legs into holes and firm earth around to secure.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>