OLIXIS 2457 Office Executive Head Support Chair Instruction Manual

OLIXIS 2457 Office Executive Head Support Chair

Specifications

• Package List:
  • (1)*1
  • (2)*1
  • (3)*2
  • Back
  • Seat
  • Armrests
  • (4)*1 Seat Plate
  • (7)*5 Base Legs
  • (5)*1 Gas Lift
  • (8)*5 Casters
  • (6)*1 Star Base
  • (9)4 Bolts M620mm
  • (10)8 Bolts M625mm
  • (11)10 Bolts M614mm
  • (12)*8 Plastic Caps
  • (13)*1 Wrench

Package List

Without further ado, we kindly suggest you list all the parts needed for the chair first.

Assembly Instruction

STEP 1 : Connect Star Base(6) and Five Base Legs(7) with Ten M6*14mm Bolts(11), then turn the Star Base upside down, and press the Casters(8) into the holes at the end of each base leg.

STEP 2 : Turn the Star Base upright and insert the Lift(5) into the center hole of the Star Base.

STEP 3: Align the Seat Plate(4) over the pre-drilled holes underneath the Seat Cushion(2), make sure that the front of the seat plate is facing the front of the Seat Cushion. Attach the Seat Plate to the Seat Cushion using Four Bolts M6*20mm(9), tighten all the bolts with the Wrench(13), being careful not to miss-thread the bolts or damage the seat.

STEP 4 : Turn the Seat Cushion(2) upright and align the center hole of the until the connection is secure.

STEP 5 : Attach the Arms(3) to the Seat Cushion(2) with Four Bolts M6*25mm(10), using the Wrench(13).

• Note 1 : Arm rests are labeled with an “L” (left) or “R” (right) to show which sides they should be placed on.
• Note 2: Do not tighten all the bolts to 100%, make sure it have space to adjust in the next steps.

STEP 6 : Lay the Back Cushion on the seat of the chair with the top of the cushion toward the front. Attach the Back Cushion(1) to the Arms by inserting Two Bolts M6*25mm(10) in the Lower holes with the Wrench(13).
Note: Do not tighten all the bolts to 100%, make sure it has space to adjust in the next steps.

STEP 7 : Rotate the back of the chair up, then secure it with the Top Two Bolts M6*25mm(10) with the Wrench(13). Adjust the balance on each side of the chair, and fully tighten all the bolts at this step.

STEP 8: Press the Plastic Caps(12) into the Arms holes to cover the bolts.

CAUTION: Make sure all bolts and screws are fully tightened before using a chair. Lubricate all moving parts and tighten all bolts/screws every 6 months or whenever needed.

Instructions For Use

Operating the tilt lockout

• To let your chair tilt back, pull the control handle out.
• To stop your chair from tilting, sit forward, then push the control handle in.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>