OVERMAX X-Rally 2.0 Remote Controlled Car RC Car User Manual

June 15, 2024
OVERMAX

OVERMAX-logo

OVERMAX X-Rally 2.0 Remote Controlled Car RC Car

The product complies with requirements of EU directives. Pursuant to the Directive 2012/19/EU, this product is subject to selective collection. The product must not be disposed of along with domestic waste as it may pose a threat to the environment and human health. The worn-out product must be handed over to the electrics and electronics recycling center.

INTRODUCTION

Dear customer!
Thank you for placing trust in us and choosing Overmax. Thanks to the use of high-quality materials and modern solutions, we provide you with a product perfect for everyday use. We are convinced that the product will satisfy your requirements as it has been designed with utmost care. Before you start using the product, please read this manual carefully. Should you have any remarks or questions concerning the product, please do not hesitate to contact us: pomoctechniczna@overmax.pl

Important:
Please read this manual before you start using the product to see all its functions and use them in accordance with intended use.

  1. Do not repair or modify the device. Only an authorized service technician is allowed to perform these operations.
  2. Do not switch the device on if you have noticed any damage.
  3. Do not use the device when it acts up, has been dropped or immersed in water, overheats extensively, is discolored or deformed, and when other atypical circumstances occur. Contact the manufacturer’s authorized service center.
  4. Never leave the charging battery unattended.
  5. The device is intended for children aged above 8. Do not let younger children play with it.
  6. Use the device away from sources of heat, high temperatures, hot surfaces, direct sunlight, source of ignition, naked flame, oils and sharp edges.
  7. Do not use the device in inflammable, explosive or toxic atmosphere.
  8. Do not use chemicals to clean the device.
  9. After every use, switch the device off and disconnect the battery.
  10. Do not immerse the entire device in water or other liquids. Do not use
  11. Before you start cleaning or moving the device, switch it off.
  12. Do not use the device for other purposes than designed.
  13. Keep the device away from sharp items.
  14. Do not place other items on the device when you use it.
  15. Use the device on flat and hard surfaces only. Avoid going on sand, grass or other surfaces which may lead to damage.
  16. To charge a battery, use a supplied charging cord only.
  17. After every charging, disconnect the USB cable from the USB port.
  18. Pay attention to battery polarization in the device and controller.
  19. In the device use the supplied battery only, in the controller two batteries AA 1,5V are used (they are not supplied). In the controller do not use storage batteries.
  20. After the use, do not touch a car engine because it may be extremely hot.
  21. Transformer, power supply, or battery charger used with the electric toy shall be regularly examined for damage to the supply cord, plug, enclosure or other parts, and in the event of such damage, it shall not be used until the damage has been repaired.
  22. The toy must not be connected to more power sources than recommended.
  23. Recharge the batteries only under adult supervision.
  24. Batteries must be removed from the toy before charging.
  25. Do not use different types of batteries or new and used batteries.
  26. Remove exhausted batteries from the toy.
  27. Power terminals should not be short-circuited.
  28. Non-rechargeable batteries should not be recharged.

DEVICE OUTLINE

CONTROLLER OUTLINE

HOW TO ASSEMBLE BATTERY IN THE CONTROLLER

  1. Loosen the screw of the battery cover with a screwdriver. Remove battery cover.
  2. Insert two batteries AA 1,5 V. Pay special attention to battery terminals.
  3. Put the cover back on. Tighten the screw with a screwdriver.OVERMAX-X-Rally-2.0-Remote-Controlled-Car-RC-Car-fig-3

HOW TO CHARGE CAR BATTERY

  1. Connect the charger to a USB port on your computer or to a USB power adapter. Then connect the battery to the charger. During charging the LED lights up. When the battery is charged, the LED will turn off.
  2. Unscrew the camping screw from the car battery cover and remove it.
  3. Connect the battery, close the cover and screw it back on.OVERMAX-X-Rally-2.0-Remote-Controlled-Car-RC-Car-fig-4

HOW TO USE

  1. Set the car switch into ON.
  2. Slide the controller switch into ON. Power LED will start flashing. Wait about 15 seconds until the controller has connected with the car. LED will go on continuously.
  3. To go forward, move the choke valve to the back. The stronger the movement, the higher the speed of the car. Move the choke valve to the front, to stop and reverse.
  4. Turn the knob left or right to make the car turn.OVERMAX-X-Rally-2.0-Remote-Controlled-Car-RC-Car-fig-5

TURN ADJUSTMENT

If you have noticed that the car turns aside instead of going straight, you can adapt the turn with adjustment.

CLEANING AND MAINTENANCE

  1. Before you start cleaning, switch the device off and disconnect the battery.
  2. Clean the car and controller with wet cloth.
  3. Do not use chemicals to clean the device.
  4. After every use, remove sand and dust from the car.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals