OVERMAX X-Quest Set of 2 Racing Cars User Manual

: June 4, 2024
: OVERMAX

Table of Contents

OVERMAX X-Quest Set of 2 Racing Cars
Introduction
Content of the set
- List of controller parts (fig. 6)
How to use
Read User Manual Online (PDF format)
Download This Manual (PDF format)

OVERMAX X-Quest Set of 2 Racing Cars

OVERMAX-X-Quest-Set-of-2-Racing-Cars-product-image

OVERMAX-X-Quest-Set-of-2-Racing-Cars-1

OVERMAX-X-Quest-Set-of-2-Racing-Cars-2

The product complies with requirements of EU directives.
Pursuant to the Directive 2012/19/EU, this product is subject to selective collection. The product must not be disposed of along with domestic waste as it may pose a threat to the environment and human health. The worn-out product must be handed over to the electrics and electronics recycling center.

Introduction

Dear customer!
Thank you for placing trust in us and choosing Dvermax.
Thanks to the use of high-quality materials and modern solutions, we provide you with a product perfect for everyday use. We are convinced that the product will satisfy you as it has been manufactured with utmost care. Before you use the product, please read this operating manual carefully.
Should you have any remarks or questions concerning the product, please do not hesitate to contact us:
pomoctechniczna@overmax.pl
Important:
Please read this manual before you start using the product to see all its functions and use them in accordance with intended use.

Do not repair or modify the device. Only an authorized service technician is allowed to perform these operations.
The device is intended for persons above the age of 5. Do not let smaller children play with the product. Keep the product out of reach of children. Warning. Not suitable for children under 3 years. Small parts.
Do Choking not start hazard. the device if you have noticed any damage.
Do not use the device when it acts up, overheats extensively, is discolored or deformed, emits abnormal sounds, and when other atypical symptoms occur. This being the case, contact the authorized service center. Pay attention to battery poles in the device and controller.
Never leave the charging battery unattended.
Do not recharge single-use batteries which are not designed for recharging.
Do not mix various batteries, and do not use new batteries together with worn-out batteries.
Pay attention to potential signal interference when using the product. It may affect operation of the controller.
When the device slows down, it means that battery is low.
If the controller’s battery goes flat, power light stops glowing.
If you do not use the product for a long time, switch the device off and remove all batteries.
Worn-out batteries must be taken out of the toy.
Leave the battery for about 10-15 minutes until it cools down before charging.
Do not use the device at variance with its intended use.
Do not place other items on the device when you use it.
Use the device on flat and hard surfaces only. Never use the device on sand, grass or other surfaces which may cause damage to the product.
The device is intended for home use only.
Use the device away from sources of heat, high temperatures, hot surfaces, direct sunlight, sources of ignition, naked flame, oils and sharp edges.
Do not use the device in inflammable, explosive or toxic atmosphere.
To charge batteries, use only the charging cable supplied.
The source of power used for this electric toy must be regularly checked for potential damage to power cable, plug, housing or other parts. In case of any damage, it must not be used until repaired.
After use, do not touch the car motor as it may be very hot.
Do not immerse the entire device in water or other liquids. Do not use near water.
To charge batteries, use only the charging cable supplied.
When charging is completed, unplug the charging cable from USB port.
The toy must not be connected to more power sources than recommended.
Storage batteries must be charged under supervision of adult only.
Storage batteries must be taken out of the toy before charging.
Do not short circuit power terminals.

Battery: 3.7 V DC 100 mAh
Operation frequency: 2.405 – 2.475 GHz
Max output power: -30.00 dBm

Content of the set

Car RC x2 (fig. 1)
Obstacles x2 (fig. 2)
Controller x2 (fig. 3)
Battery x2 (fig. 4)
USB cable x2 (fig. 5)
Screwdriver x2 (fig. 5)

List of controller parts (fig. 6)

Power light
Left/right turning knob
On/off key
Speed adjustment
Go forward/reverse control throttle
Protective cap x2 (6 – fig. 6)

How to install batteries in the controller
Open the battery cover (fig.?). Insert two batteries AA 1.5V. Pay special attention to battery poles. Close the battery cover.

How to charge and install batteries in the car

Connect the battery to USB cable, and then connect USB cable to PC or USB charger (fig. 8). We recommend the charger 5V DC 2A.
The red power light means charging. If the power light is off, it means the battery is full.
Open the battery cover in the car with the use of screwdriver supplied (fig. 9), and next insert the full-battery plug in car plug. [lose the battery cover (fig. 10).
When you no longer use the device, it is advisable to charge the battery for about 25 minutes. If you do not use the device for a long time, it is advisable to discharge the battery and fully recharge it once a month.

How to use

Remove the foil before use.
Put the protective cap over the controller.
Start the car by sliding the switch into ON (fig. 11). Do the same with the controller.
Place the car on a flat surface. Wait for about 15 seconds so that the controller can pair with the car. Power light will start glowing continuously and the car will be ready for operation.
To go forward, slide the throttle backwards. To reverse, slide the throttle forward. The farther you slide it, the faster the car goes.
To turn left, turn the know in an anti-clockwise direction. To turn right, turn the knob in a clockwise direction.
To increase speed from default low, press the speed switch. The car will glow twice. To restore low speed, press the speed switch again.

How to clean and maintain