WILLIAMS AV ANT034 Remote Rubber Duckie Antenna Instruction Manual
- June 14, 2024
- Williams AV
Table of Contents
AV ANT034 Remote Rubber Duckie Antenna
Instruction Manual
ANT034 Remote Rubber Duckie Antenna
Model ANT 034
Remote rubber duckie antenna for RPK-005 mounting
The ANT 034 is a 75 Ohm rack mountable remote antenna designed for 72-76 MHz
operation. It is intended for use with Williams AV FM transmitters (i.e. T27,
T45, T55, T55C).
Note: The FCC requires this antenna to be professionally installed.
ANT 034 Assembly & Installation Procedure
- The ANT 034 can be mounted to an audio rack with the RPK 005 (a 1/2-width, single-space rack bracket, ordered separately). This solution is most commonly used when the transmitter will also be mounted in the rack.
- Thread the ANT 021 rubber duckie on to the ANT 035. Turn the F-connector on the ANT 021 clockwise by hand until connection is tight.
- Install the washers with the smaller side facing the RPK 005 rack bracket as shown. Correct orientation of the washers is crucial to maintaining antenna isolation. Tighten the nut with moderate pressure using the proper size wrench.
- Thread one end of the WCA 086 3’ coax cable on to the back of the assembled bracket-antenna unit. Use fingers only to tighten.
- Attach other end of WCA 086 3’ coax cable to the F-Connector Antenna jack on the Williams AV 72-76 MHz transmitter (i.e. T27, T45, T55, T55C). Use fingers only to tighten.
NOTE: Do not bend coax cable sharply at any point. The ANT 034 rubber duckie antenna should be vertical for best performance, and to comply with FCC rules.
90 Day Warranty
The ANT 034 rack mountable remote antenna is covered by a 90 day warranty. If
you experience difficulty with your antenna, call toll-free for customer
assistance:
1-800-843-3544 (U.S.A.) or
1-952-943-2252 (Outside the U.S.A.)
*For a Complete Warranty Statement go to: https://williamsav.com/support/warranty-product-registration/
If it is necessary to return the system for service, your Customer Service
Representative will give you a Return Authorization Number (RA) and shipping
instructions.
Pack the system carefully and send it to:
Williams AV
Attn: Repair Dept.
10300 Valley View Road
Eden Prairie, MN 55344
Recycling Instructions
Help Williams AV protect the environment! Please take the time to dispose of
your equipment properly.
Product Recycling for Customers in the European Union:
Please do NOT dispose of your equipment in the household trash. Please take
the equipment to a electronics recycling center.
WilliamsAV.com
U.S. | 800.843.3544 info@williamsav.com INTL | +
MAN 174D-822
+1.952.943.2252 info-intl@williamsav.com
© 2022, Williams AV, LLC
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>