ALEASHA 2324100 Widespread Bathroom Sink Faucet Matte Black Instruction Manual
- June 14, 2024
- ALEASHA
Table of Contents
ALEASHA 2324100 Widespread Bathroom Sink Faucet Matte Black
You may need
For easy installation of your faucet you will need:
- To READ ALL the instructions completely before beginning.
- To READ ALL warnings, care, and maintenance information.
- With 1.2 gpm are compliant with California water efficiency regulations, comply with California Proposition 65, and with the Federal Safe Drinking Water Act.
- In areas with extremely low water pressure causing the basin faucet water flow to be unsatisfactory, replace the 2.2 gpm aerator to improve the water flow in the basin faucet.
Cleaning and Care
- Care should be given to the cleaning of this product. Although its finish is extremely durable,
- It can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel.
Dimension
OPERATION
- Double lever style handles
- Maximum handle(s) rotation angle is 90 to full-on
- Rotate the hot side counter-clockwise to open (clockwise to close)
- Rotate the cold side clockwise to open (counter-clockwise to close)
INSTALLATION INSTRUCTION
NOTES
- Before installing the valves, clean the water pipe thoroughly to avoid dirt and deposits.
- Make sure to attach the gasket to the spout (1).
- Slide spout (1) through the sink.
- Place washer(2) and metal plate (3) over mounting stud under the sink. Secure with mounting nut(4).
- Lock mounting nut(4) into position by tightening screw (5).
Attach flexible hoses under the hot and cold end valves.
- Make sure to attach the gasket to the base of the hot (1) and cold (2) end valves.
- Slide hot (1) and cold (2) end valves with flexible hoses (3) through the sink.
- Place washer(4) and metal plate(5) over mounting stud under the sink. Secure with mounting nut(6).
- Lock mounting nut(6) into position by tightening screw (7).
- NOT WITH apply teflon tape to the quick connect installation.
- Align tabs and tabs on quick connects.
- Push quick connects firmly upward and snap onto receiving tube tab. Pull down moderately to ensure each connection has been made.
- Remove the washer (2) , black gasket (4) and nut (5) from the assembly.
- Slide washer (2) up to underside of flange (3). Insert flange (3) and washer (2) into sink and secure with the black gasket (4) washer and nut (5) from underneath the sink.
- Put down and check the Springloaded stopper (1 ).
- Connect assembly to drain.
To flush debris from the plumbing system:
- Remove the aerator by hand.
- Run hot and cold water for one minute.
- Replace the aerator.
- Repeat for other hose connection making sure the hose with the hot label is connected to the hot supply valve and the other hose is connected to the cold supply valve.
- FLUSH SYSTEM/CHECK FOR LEAKS. Turn on hot and cold water supplies and flush water lines for one minute. Check all connections at arrows for leaks.
- Retighten if necessary, but do not overtighten.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>