ALEASHA 2323100B Two Handle Lavatory Centerset Faucets Instruction Manual

: June 14, 2024
: ALEASHA

Table of Contents

2323100B Two Handle Lavatory Center set Faucets
OPERATION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TWO HANDLE LAVATORY
CENTERSET FAUCETS
2323100B
1.2GPM 4.5L/min

2323100B Two Handle Lavatory Center set Faucets

You may need

For easy installation of your faucet you will need:
To READ ALL the instructions completely before beginning.
To READ ALL warnings, care, and maintenance information.
With 1.2 gpm are compliant with California water efficiency regulations, Complies with California Proposition 65 and with the Federal Safe Drinking Water Act. In areas with extremely low water pressure causing the basin faucet water flow to be unsatisfactory, replace the 2.2 gpm aerator to improve the water flow in the basin faucet.
Cleaning and Care
Care should be given to the cleaning of this product. Although its finish is extremely durable, It can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel.

OPERATION

Double levers style handles
Maximum handle(s) rotation angle is 90 to full on
Rotate hot side counter clockwise to open ( clockwise to close)
Rotate cold side clockwise to open (counter clockwise to close)

Notes
Before installing the valves, clean the water pipe thoroughly to avoid dirt and deposits.

Attach thread rod (2) under faucet body (1)
Make sure attach the O-ring(3) to the base of faucet body.
Slide tubes (4) down through mounting hole and faucet on sink.
Place washer(5) and metal plate(6) over thread rod(2) under sink.
Secure the M8 nut(7) to the thread rod (2) with too(8)

Remove the brass lock nut from the thread rod counter-clockwise, remove the washer and washer.

Make sure attach the gasket to the base of hot (1) and cold (2) end valves.
Slide hot (1) and cold (2) end valves with flexible hoses (3) through sink.
Place washer(4) and metal plate(5) over mountingstud under sink. Secure with mounting nut(6).
Lock mounting nut(6) into position by tightening screw (7).

NOT WITH apply Teflon tape to the quick connect installation. Align tabs and tabs on quick connects.
Push quick connects firmly upward and snap onto receiving tube tab . Pull down moderately to ensure each connection has been made.

Remove the washer (2), black gasket (4) and nut (5) from the assembly.
Slide washer (2) up to underside of flange (3). Insert flange (3) and washer (2) into sink and secure with the black gasket (4) washer and nut (5) from underneath the sink.
Put down and check the Spring-loaded stopper (1 ).
Connect assembly to drain.

To flush debris from the plumbing system:

Remove the aerator by hand.
Run hot and cold water for one minute.
Replace the aerator.

Repeat for other hose connection making sure the hose with the hot label is connected to the hot supply valve and the other hose is connected to the cold supply valve.
FLUSH SYSTEM/CHECK FOR LEAKS.
Turn on hot and cold water supplies and flush water lines for one minute. Check all connections at arrows for leaks. Retighten if necessary, but do not overbig then.

unit: inch (mm)