KORGOL IN CHINA Electric Standing Ergonomic Desk Instruction Manual
- June 14, 2024
- KORGOL
Table of Contents
KORGOL IN CHINA Electric Standing Ergonomic Desk
IMPORTANT INFORMATION READ CAREFULLY.
KEEP THIS INFORMATION FOR FURTHER REFERENCE.
GENERAL GUIDELINES
- Please read the following instruction carefully and use the product accordingly.
- Please keep this manual and hand it over when you transfer the product.
- This summary may not include every detail of all variations and considered steps. Please contact us when further information and help are needed.
NOTES
- Please follow the assembly instructions precisely and only use the product as intended.
- If an odor is present when first opening the package, please leave the unwrapped product in a shaded and ventilated area for a few days to air out.
- Prior to assembly, please check the product for defects or missing accessories. If any defects are found or accessories are missing, do not use product as damage or injury may occur;
- Please contact us for assistance and replacement.
- During assembly, please only slightly tighten all screws in their correct position first, then fully tighten them. A Philips screwdriver is recommended but not included.
- It is suggested you regularly check the products bolts and connections to ensure safe use.
- Assemble the item on a soft flat and clean surface to avoid scratches and damage.
WARNING
- During assembly, keep parts and packaging materials away from children and pets as there could cause injury and are a potential choking hazard.
- Avoid sharp objects or corrosive chemicals to prevent damage to the product.
- Please open the item slowly and cautiously to avoid pinching your hands by metal joints, especially children.
Components
Please check you have all the pieces listed below
WHAT IS IN THE BOX
Notice!
When the screw is tightened, do not continue to tighten it forcefully,
otherwise the screw may be damaged.
INSTULATION INSTRUCTION
Note :The horizontal bar on the iron connector should be perpendicular to the seam of the table panel splice.
Install the another ® -Support Beam on the other side in the same way as in step 3.
Note： please pay attention to the direction of the Side Brakets when installing
Firstly, insert the hexagonal rod into the main shaft of the table leg without motor and then lock the plastic nut. Secondly, put the other side of the coupling rod into the pre-built rod on the motor leg and then lock
Install the frame on the desktop.
Install K -AC Adapter,B -Controller on the desktop.
Stand the desk up and press the outlet box firmly into the desk.
Connect Controller,AC Adapter,Power Cable and Left Leg.
CONTROLLER INSTRUCTION
Trouble shooting Guide:
If your standing desk does not work properly,you may need to reset it. If any error codes appears,you need to reset it.If it still does not work after the reset, please contact us for more help.Maintenance and Consideration:
- During daily maintenance,use a clean soft cloth to remove surface dust.Do not use a wet cloth or hard material to wipe the surface of the table.
- Avoid contacting the surface with acid-based chemicals.
- For slight scratches,gentle wipe with a soft cloth,you can smooth out scratches.Avoid attaching tape directly to the outer surface of the metal feet to prevent paint from peeling.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>