LIANQIAN TCH-500 Electric Candy Floss Machine Instruction Manual

Candy floss Machine
Pink Electric Commercial Cotton Candy Machine
Instruction Manual

Model:TCH-500

Please read the introduction before using it

WARNING: IMPORTANT SAFETY INFORMATION
READ AND FOLLOW ALL SAFETY REQUIREMENTS
KEEP THIS MANUAL IN A SAFE AND DRY PLACE FOR FUTURE REFERENCE
If you do not understand these directions, or if you have any doubts about the safety of the installation, please contact qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious
injury. Do not use this product for any purpose that is not explicitly specified in this manual and do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or inappropriate use.

PRODUCT SPECIFICATIONS

PREPARATION

1. Taking the machine out of the package, please clean the heating head and the stainless steel pan with warm, soapy water (do NOT use detergent type cleaners).When the head is turned on, it will clear the water from the machine. Make sure to dry the pan completely.
2.  The cotton candy machine should be placed on a dry, flat stable surface.
3. Make sure all parts are properly installed before plugging in the machine.

OPERATING INSTRUCTIONS

1. Turn on the power switch. Let the machine run for 1-2 minutes to allow the motor and drive belt to warm up for best performance. The machine may vibrate while running; this is normal and will not affect operation. After the motor has warmed up, turn on the heating switch and allow the head to warm up for 2-3 minutes.

2. After heating, pour one scoop full of sugar into the center of the heating head.
   Note: Only use corn syrup based hard candies with a slightly transparent appearance such as Jolly Rancher and Life Savers. Pressed sugar and other hard candies like Smarties may not melt properly, thus clogging the head.

3. The candy floss will get out after 30 seconds, then use a bamboo stick or other related object to stick the candy floss, revolve follow the inside of the pan. (the bamboo stick need clean with wet cloth)

4. When finished making candy floss, keep machine hot and running while cleaning the heating head by slowly pouring a small amount of water into the center. Keep water spinning through until color inside is closer to the bare aluminum again. Allow machine to cool, and wipe down head with a damp cloth to clean off excess sugar. Stainless steel pan may be cleaned with warm soapy water.

ATTENTION

1. Children are forbidden to use this machine.
2.  Have to use electrical outlet with ground line. Keep the cable away from the heat. Don’t immerse the cable,electrical plug and the machine into water or other liquids. Don’ t use the broken cable, electrical outlet and plug.
3.  Install the heating head and pan correctly, then put into the plug. Turn off the power switch when finish working, removing the pan and clean it.
4. Don’t touch the surface of the heat and heating head when working, and don’t put the hand into the pan if still sugar inside, in case of being burnt, and also don’t move machine when working.
5.  The temporary piece rate of electric motor of is 80%, pls avoid the long time continuous working as to prolong the service life of the electric motor, it should pause for 20 minutes after working continuously for an hour.
6.  No matter cleaning the machine, or maintaining it, it should close power supply, and pull out electrical plug firstly; Disallow this machine empty running for long hours.
7. Don’t use detergent when sweeping, since the detergent left on the machine will result in pollution. It also can’t be washed with water directly, for this may moisten the electric spare parts and damage the machine.
8. If the heating head doesn’t run, pls turn off the power switch, clean the burnt sugar inside.
9. If the strap become loose after long time working, just need remove and replace it.

LECTRICAL DATA

L———- 3×1.0 Cu wire
K———- 15A/110V Switch
Fu——— 10A fuse
D———- 30W/110V Ac motor
W———- 110V linearity booster
V———- 110V Ac voltage meter
R———- 980w/110V heating piece
L———- 3×1.0 Cu wire

WARRANTY
We offer a 90 days warranty for this product. If you have any problems with the machine, please contact us directly. We have a 30 Day Return Policy.
LIANQIAN CANDY FLOSS MACHINE

Get In Touch| Monday-Friday from 7:00am-7:00pm
LIANQIAN.HSJSM@outlook.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>