Waterdrop WD-RF10 Water Filter Instruction Manual
- June 14, 2024
- Waterdrop
Table of Contents
Installation Instructions
Replacement Filter for Undersink Water Filtration System
WD-RF10 Water Filter
Certified by WQA against NSF/ANSI Standards 42 in model EWF-8016S/EWF-8017S /EWF-80185S for the reduction of the claims specified on the Performance Data Sheet, and to NSF/ANSI 372 (<0.25% lead).
Specifications
| Operating temperature | 2-38°C/35-100°F |
|---|---|
| Working pressure | 10-100psi (0.7-6.8bar) |
| Flow rate | 0.75gpm (2.83Ipm) |
| Filter capacity | WD-RF10/WD-RF10-UF/MZ/AK: up to 11,000 gallons |
WD-RF15/WD-RF15-UF/MZ/AK: up to 19,000 gallons
WD-RF17/WD-RF17-UF/MZ/AK: up to 24,000 gallons
Feed water requirement| Municipal tap water
Note:
- If using well water as the source, please make sure the feed water has been through a pre-filtration system, otherwise, large particles in well water will clog the filter easily and shorten filter life.
- The above form lists model numbers of only black filters. Please note that the white filter is different from the black filter only in color. They have the same filter material and filtration capacity.
- Actual filter life varies according to local water quality.
Precautions **
**
- Do not use it with water that’s microbiologically unsafe or of unknown quality without adequate disinfection.
- For use only with cold water.
- Do not freeze the filter, as this can cause cracking and water leakage.
- Do not allow children under 3 years old to have access to small parts during installation of this product.
- This installation must comply with all applicable state and local regulations.
- Turn off the water supply while replacing the filter.
**Filter replacement
**
- It’s recommended to turn off the water supply and turn on the faucet to release the water pressure.
- Rotate 1/4 turn to the left to remove the filter.
- Take out the new filter and remove the protective cap.
- Rotate 1/4 turn to the right to install the filter. Ensure that the filter’s triangle mark is aligned with the connection mark.
- Turn on the cold water valve and flush for 5 minutes.
Frequently asked questions
Q: Why doesn’t the TDS value lower after filtration?
A: The main purpose of this Waterdrop filter is not to remove TDS. TDS stands
for total dissolved solids, and it is basically composed of inorganic salts
and a small amount of organic matter. The filter can remove harmful substances
while keeping beneficial trace elements. Please choose Waterdrop RO system if
you are looking for physical removal of TDS.
Q: When should I replace the filter?
A: The filter’s service life is related to the water quality. If the flow rate
is significantly reduced or if the water has a peculiar smell, we suggest that
you replace the filter. The recommended service life of the filter is as
follows: 1 year for WD-RF10, WD-RF10-UF, WD-RF10-MZ and WD-RF10-AK, 2 years
for WD-RF15, WD-RF15-UF, WD-RF15-MZ and WD-RF15-AK, 3 years for WD-RF17, WD-
RF17-UF, WD-RF17-MZ and WD-RF17-AK.
Q: Why does my water taste bad?
A: The filter will produce unpleasant odor if it hasn’t been used for along
time, especially for WD-RF10-UF, WD-RF15-UF, and WD-RF17-UF. If such a problem
occurs, please flush the filter for 5 minutes before use. It could also be
time to change the filter cartridge.
Performance data sheet (Filter Model No.)
WD-RF 10-MZ/WD-RF 10-AK/WD-RF 10/WD-RF 10W/WD-RF 10-UF/WD-RF 10W-UF/WD-RF 10W-
AK/ WD-RF 10W-MZ/WD-RF 15/WD-RF 15-UF/WD-RF 15W/WD-RF 15W-UF/WD-RF 15-AK/WD-RF
15-MZ/ WD-RF15W-AK/WD-RF15W-MZ/WD-RF 1 7/WD-RF17-UF/WD-RF 17W-UF/WD-RF 1 7W
/WD-RF 1 7-MZ/ WD-RF17-AK/WD-RF17W-AK/WD-RF17W-MZ
Substance reduction
The system has been tested and certified by WQA according to NSF/ANSI Standard
42 and NSF/ANSI Standards 372. The concentration of the indicated substances
in water entering the system was reduced to a concentration less than or equal
to the permissible limit for the water leaving the system, as specified by
NSF/ANSI Standard 42. While testing was performed under standard laboratory
conditions, actual performance may vary.
Performance Data Sheet
Substance| Inf. Average| Specified Challenge Concentration| Ave. % Reduction
Chlorine Taste and Odor| 2.0 mg/L| 2.0 mg/L ± 10%| 93.%
Average Product Water| Max Permissible Product Water| Reduction Requirements
0.05mg/L| N/A| ≥50%
System to be used with municipal or well water sources treated and tested on
regular basis to ensure bacteriological safe quality. Do not use with water
that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system. Testing was performed under standard
laboratory conditions, actual performance may vary.
WARNING Please read it carefully before installation.
The system and installation shall comply with applicable state and local
regulations.
Designed by Hongkong Ecoaqua Co., Limited.
Manufacturer Technical Support
Tel: 1-888-352-3558 (U.S.)
E-mail:service@waterdropfilter.com
vo40
Made in China
Qingdao Ecopure Filter Co., Ltd.
Documents / Resources
|
Waterdrop WD-RF10 Water
Filter
[pdf] Instruction Manual
WD-10UA, WD-10UB, WD-RF10 Water Filter, Water Filter, Filter
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>