CTA ADD-PARAF1V VESA Compatible Floor Stand Workstation Instruction Manual
- June 14, 2024
- CTA
Table of Contents
ADD-PARAF1V VESA Compatible Floor Stand Workstation
VESA Compatible
Graphic Floor Stand Workstation
ADD-PARAF1V
INSTRUCTION – MANUAL
CONTENTS:
INSTALLING BASE:
1A. ALIGN BASE PLATE (A) WITH THE
BODY (J) AND ROTATE IN SCREW (H) FROM THE BOTTOM USING THE PROVIDED ALLEN KEY
TOOL (E).
SETTING UP GRAPHIC CARD SLOT
2A.
SLIDE OUT THE (2) GRAPHIC CARD PANELS IN THE FRONT AND BACK OF THE BODY (J).
IF THERE IS A STICKER FILM, REMOVE THAT FIRST. IF YOU HAVE PRINTED OUT A
STICKER GRAPHIC, PLACE IT ONTO THE PANEL. IF YOU ARE USING A COMPLETE NEW
PANEL, YOU CAN REPLACE THE INITIAL PANELS THAT CAME WITH THE FLOOR STAND.
PLACE ONE PANEL BACK FIRST, THEN THE OTHER.
SETTING UP CABLE ROUTING
3A. WITH ONLY
(1) PANEL BACK IN, SLIDE IN THE POWER CORDS AND ANY OTHER CORDS THAT WOULD
NEED TO BE CONNECTED TO THE TABLET THROUGH THE BODY AS SHOWN. THERE WILL BE
GAPS AT THE TOP AND BOTTOM FOR THEM TO ROUTE OUT TO THE POWER SOURCE AND TO
THE DEVICE. SLIDE IN SECOND PANEL WHEN ROUTING IS FINISHED.
INSTALLING THE TRAY, GOOSENECK & VESA
4A. USING THE SMALL FLAT HEAD
SCREWS (E), ROTATE IN THE SCREWS TO THE VESA (D) WITH THE PROVIDED TOOL (E)
UNTIL SECURELY FASTENED. 
4B, ROTATE IN
THE ATTACHED GOOSENECK WITH THE VESA (D+C) TO THE TRAY TABLE (B) AS SHOWN WITH
THE SMALLER FLAT HEAD SCREWS (I) WITH PROVIDED TOOL (E)
4C. BEFORE ATTACHING TRAY TABLE COMPONENT, TAKE THE
CABLE THAT’S ALREADY BEEN FISHED THROUGH KIOSK BODY AND FISH IT THROUGH THE
GOOSENECK AND OUT THE VESA HOLE AS ILLUSTRATED ABOVE.
ALIGN THE TRAY HOLES TO THE KIOSK TOP, ROTATE IN SCREWS (H) INTO THE TRAY THEN
INTO THE STAND WITH PROVIDED TOOL (E) UNTIL SECURE FASTENED.
36 Taaffe Place Brooklyn, NY 11205
support@ctadigital.com
888-733-4448
www.ctadigital.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>