CTA PAD-HFSVP VESA Compatible Heavy Duty Height Adjustable Rolling Floor Stand User Manual
- June 3, 2024
- CTA
Table of Contents
VESA-Compatible Heavy-Duty
Height-Adjustable Rolling Floor Stand
USER MANUAL
PAD-HFSVP
PAD-HFSVP VESA Compatible Heavy Duty Height Adjustable Rolling Floor
Stand
Contents:
Instructions:
1. Installing the Wheels
1A. Take one wheel (E) and align it to the leg arm holes on the underneath of
the base (H). Initially you can use your hands and manually rotate the wheel
until slightly tightened. Then use the provided wrench tool (B) at the hex
shaped area and rotate it securely to tighten the rest of the way.
2A.
Press the wheel lever up or down to place wheels in locked or unlocked mode
depending if you want to be in a mobile or stationary setup. Make sure you
adjust all wheels at the same time or it won’t properly be set up.
2. Attaching Base to Body
2A. Align the bottom of pole body (D) to the top center of the base (H). While
pieces are connected, securely flip over so you can see the bottom. Align
washer (C) to the hole on the bottom. Using your hands, identify L-shaped
component (F) and rotate through the washer into the hole until securely
tightened. Pole body and base should now be securely attached to each other.
3. Cable Routing Through Pole Body
This product allows you to go through the cable from the cable routings on the
pole.
-
Set the pole to its lowest position. Insert cable head through bottom pole and push upward.
-
Pinch cable head at top pole opening and extend pole height, keeping cable pinched.
-
Draw cable head out from pole opening.
4. Assembling Extender Pole & VESA Plate Component
4A. First add the body extension pole (G) by rotating onto the main body pole (D). Connect the male to female adapters and rotate until securely attached. Afterwards, repeat the same exact process for VESA add-on component.
36 Taaffe Place Brooklyn NY 11205 rd.
[email protected]
ts 888-733-4448
www.ctadigital.com