CTA Auto-Sam Laptop Security Arm with VESA Mounting Base for Vehicles Instruction Manual
- June 6, 2024
- CTA
Table of Contents
CTA Auto-Sam Laptop Security Arm with VESA Mounting Base for Vehicles Instruction Manual
Instruction Manual
Package Contents:
Instructions:
1.Connecting the Holder to the Laptop Plate Base
Take the laptop holder and align the holes on the bottom of the middle joint to the holes on laptop plate as shown. Using the provided tool, screw in the screws from below into the bottom of the laptop holder joint until securely tightened.
2.Connecting the Laptop Holder Plate Base to the VESA Joint as shown below
Align the VESA holes of the laptop plate with the VESA mount as shown. Using the provided tool, screw the (4) screws from above the plate through both the plate and VESA mount while holding the (4) hex nuts from behind with your hand. Keep screwing until tight and secure.
3. Installing your Laptop to the Holder Plate Base
4. Adjusting Joints
4A. Turn the knob counterclockwise to loosen any of the joints on the vehicle mount. Adjust the arm to the desired angle and position, then rotate clockwise to tighten and secure the position.
5. Attaching Car Seat Rail Clamp to Multi-Flex Pole
Choose from the different rail options mounting options that best matches your car/vehicle railing.
The following (3) clamps allow you to connect from the bottom of Multi-Flex Pole setup.
These two clamps allow you to connect the side of the Multi-flex pole
6. Installing the rail mount to your vehicle
When connecting to the car seat rail – Choose from the following (4) rails as shown below
When connecting to the car floor or console – Use the (1) rail as shown below
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>