CVLIFE SFD-065C Magnetic Charging White Light Flashlight User Manual
- June 14, 2024
- CVLIFE
Table of Contents
CVLIFE SFD-065C Magnetic Charging White Light Flashlight
SPECIFICATIONS
IN THE BOX
PRODUCT OVERVIEW
NOTICE: The charging indicator will light up red when the battery is being charged and turn green when fully charged.
LIGHT INSTALLATION
- Pull the swing arm to open.
- Adjust the sliding rail of the light to your desired position.
- Close the swing arm. (If it cannot be closed, please loosen the opposite screw slightly, same as step 4.)
- Adjust the screw to make it tight. (Usually, it can be installed firmly without adjustment, unless you feel the light is loose.)
OPERATION
CAUTION: The light provides a powerful beam. When operated for a long
time, it will get uncomfortably warm. This is normal and not a defect.
SELECT THE LIGHT MODE
Rotate the Switch-knob to select 3 different modes: LIGHT ONLY /LASER
ONLY/LASER LIGHT COMBO.
MOMENTARY ON
Press either switch at least 3s and hold it down, the light will stay on until
the switch is released.
CONSTANT ON
Click either switch once and release it immediately, then the light will stay
on. Single click again to turn the light off.
STROBE MODE
When the mode is set to LIGHT ONLY/LASER LIGHT COMBO and the light is OFF,
click the switch twice quickly to change to strobe mode (The time interval
between pressing the switch continuously must be less than 0.5s).
DANGER
- DO NOT throw the light directly into human eyes. It may cause temporary blindness, or permanent damage to the eyes.
- DO NOT cover the light head when the flashlight is on, or place the flashlight on the ground. The radiation energy of the flashlight may cause damage to the flashlight itself, or even result in burning to other materials.
- DO NOT use rechargeable lithium batteries without a protection circuit. It may result in battery damage or unpredictable disasters.
- DO NOT leave the light in any fabric bag or fusible plastic container the high temperature.
NOTE Please feel free to contact us if you encounter the following problems:
- The product is damaged or cannot be installed.
- The product cannot be charged or needs reparing.
- Unable to adjust the laser.
- Missing accessories.
Thank you for your purchase!