TOWER T637000 Metal Pedestal Fan User Manual
- June 14, 2024
- TOWER
Table of Contents
TOWER T637000 Metal Pedestal Fan
This box contains
- Front Guard
- Locking screw
- Fan Blade
- Rear Guard
- Front Guard Nut (x1)
- Telescopic Stand
- Pivot Adjustment Screw
- Tilt Adjustment Screw
- Motor Housing
- On/Off/Speed Control
- Oscillating Control
- Motor Spindle
- Fan Blade Retaining Screw (x1)
- Guard Retaining Clips
- Stand Base
- Weight
- Clamping Washer
- L – Shaped Screw
Technical Data
- Description: 16 Inch Pedestal Fan
- Model: T637000 aplicable to all colour variants
- Rated Voltage: 220-240V~
- Frequency: 50-60Hz
- Power consumption: 50W
DISPOSAL OF THE UNIT
- Appliances bearing the symbol shown here may not be disposed of in domestic rubbish.
- You are required to dispose of old electrical and electronic appliances like this separately.
- Please visit www.recycle-more.co.uk or www.recyclenow.co.uk for access to information about the recycling of electrical items.
- Please visit www.weeeireland.ie for access to information about the recycling of electrical items purchased in Ireland.
- The WEEE directive, introduced in August 2006, states that all electrical items must be recycled, rather than taken to landfill.
- Please arrange to take this appliance to your local Civic Amenity site for recycling, once it has reached the end of its life.
Important Safety Information
Please read these notes carefully BEFORE using your Tower appliance:
- Check that the voltage of the main circuit corresponds with the rating of the appliance before operating.
- Please ensure that the appliance is used on a stable, level, and heat resistant surface.
- DO NOT immerse cords, plugs or any part of the appliance in water or any other liquid.
- DO NOT leave the appliance unattended while it is operating.
- Close supervision is necessary when any appliance is used by or near children or pets.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- Children shall not play with the appliance.
- Cleaning and user maintenance shall not be made by children without supervision.
- Switch off at the wall socket then remove the plug from the socket when not in use or before cleaning.
- If the supply cord or appliance is damaged, stop using the appliance immediately and seek advice from the manufacturer or its service agent or a similarly qualified person.
- DO NOT let the cord hang over the edge of a table or counter or let it come into contact with any hot surfaces.
- The use of accessory attachments is not recommended by the appliance manufacturer apart from those supplied with this product. DO NOT use extension cords with the appliance.
- DO NOT pull the plug out by the cord as this may damage the plug and/or the cable.
- DO NOT use this product for anything other than its intended use.
- This appliance is for household use only.
- appliance by the power cord.
- DO NOT use the appliance outdoors.
- DO NOT run cord under carpeting. DO NOT cover cord with throw rugs, runners or the like. Arrange cord away from traffic area to avoid anyone from tripping over.
- DO NOT insert or allow foreign objects to enter any ventilation opening as this may cause an electric shock, fire, or damage to an individual or a property.
- To prevent overload and blown fuses, be sure that no other appliance is plugged into the same outlet (receptacle) or into another outlet (receptacle) wired into the same circuit.
- We DO NOT recommend use of an extension cord as it may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord should be No: 14 AWG minimum size and rated not less than 1875 watts, and has to be used only for supplying power to this fan.
- Never insert your fingers, pencils or other objects through the cage during operation.
- The fan should be set up on a stable and level surface to avoid it being knocked over.
- DO NOT expose the fan to excessive heat or humidity as this can cause damage to the electrical components.
- The fan should be kept out of the reach of children.
- In the unlikely event the appliance develops a fault, stop using it immediately and seek advice from the Customer Support Team.
- In the unlikely event the appliance develops a fault, stop using it immediately and seek advice from the Customer Support Team.
Before First Use
Read all instructions and safety information carefully before first use. Please retain this information for future reference.
- Remove the appliance from the packaging and check for any visible signs of damage to the unit and cable.
- Assemble as instructed.
- Your appliance is now ready for normal use.
- Dispose of the packaging in a responsible manner.
- Place the unit on a firm and level surface.
Assembling Your Metal Stand Fan
- Remove the L-shaped screw (18) and clamping washer (17) from the telescopic stand (6), then atttach it to the Base (15). To do this, place the Weight (16) on the underside of the base (15) and the clamping washer (17) in the centre of the weight. Thread the L-Shaped Screw (18) through the assembly and into the thread in the Telescopic Stand (6). Tighten firmly but do not overtighten.
- Next attach the motor housing (9) to the top of the telescopic stand (6).First remove all the screws, etc. (7, 8, 19 & 20) from the motor housing bracket.
- Place the Motor Housing on the top of the stand and thread the Large Pivot Bolt (20) through the bracket and screw in the Small Retaining Screw (8) and tighten (but do not over tighten).
- Fit the Large Pivot Knob (7) onto the end of the Bolt (20) and the Small Adjusting Knob (19). Hold the fan motor upright and tighten the Large Pivot Knob (7) and the Small Adjusting Knob (19).
Assembly of your stand fan grille:
-
- Remove the 4 grille locking screws from the main body.
- Set the rear grille in the proper position with the handle up. Let the four screws go through the rear guard hole and tighten (but do not over tighten).
- Discard the plastic sleeve on the shaft. Install the blade onto the shaft until the retaining pin fits into the notch on the blade, then use the screw to fix it and tighten (but do not over tighten).
- Mount the Front Safety Grille onto the Rear Grille by hanging the top hook clip of the front guard over the top of the Rear Grille. Close the clasps all around the grille, then secure it with the locking screw and nut.
Note: When first inserting the locking screw into the corresponding holes on the rim of the fan grille, only tighten it loosely. Ensure you have secured the front safety grille as detailed above before tightening this screw in all the way; otherwise, the front safety grille may not be correctly installed.
Adjustable tilting head:
Use the top two screws to adjust the angle of the fan head. Loosen the screws
to move the head to the desired angle, and tighten them to lock into place.
CAUTION! Do not use the fan when the front guard is not locked into
place.
Note: Make sure that the fan is on a level surface and away from any
liquids.
Oscillating the fan will create a more uniform cooling effect in the room.
Using your appliance:
Choose one of the following 3 speeds using the speed dial.
- 0 Stop
- I Low
- II Medium
- III High
Oscillation:
Push down the oscillation button to activate the oscillation function. Pull
the button back up to stop the oscillation.
Cleaning and care:
Before cleaning always switch off the appliance and remove the plug from the
electrical socket. To clean the outside of the fan, wipe the exterior with a
soft, damp cloth.
Never use an abrasive cleaner.
When not in use, store the fan (preferably in its original box) in a cool,
clean and dry location.
Cleaning the fan blades:
Remove the front guard by unclipping the locking clips located around the
circumference of the guard. The top lock does not unclip. Use a small spanner
to unscrew the nut and bolt that holds the bottom of the front guard to the
back guard.
WARNING: DO NOT immerse any electrical part of the appliance in water
such as motor units or plugs. Please see cleaning section for further
instructions.
Model Identifier(s): T637000 All colour variants
Item| Symbol| Value| Unit
Maximum fan flow rate| F| 54.88| m3/min
Fan Power input| P| 48.29| W
Service value| SV| 1.14| (m3/min)/W
Standby power consumption| PSB| 0.00| W
Fan sound power level| LWA| 64.63| dB(A)
Maximum air velocity| C| 3.08| m/sec
Seasonal electricity consumption| Q| 15.45| kWh/a
Measurement standard for service value| IEC 60879:1986+ (corr. 1992)
Contact Details:| RKW LTD, Sutton House, Berry Hill Industrial Estate, Berry
Hill Road, Stoke-on-Trent, ST4 2NL
thank you!
We hope you enjoy your appliance for many years. This product is guaranteed
for 12 months from the date of original purchase. If any defect arises due to
faulty materials of workmanship, the faulty products must be returned to the
place of purchase. Refund or replacement is at the discretion of the retailer.
The Following Conditions Apply:
The product must be returned to the retailer with proof of purchase or a
receipt. The product must be installed and used in accordance with the
instructions contained in this instruction guide. It must be used only for
domestic purposes. It does not cover wear and tear, damage, misuse or
consumable parts. Tower has limited liability for incidental or consequential
loss or damage. This guarantee is valid in the UK and Eire only. The standard
one year guarantee is only extended to the maximum available for each
particular product upon registration of the product within 28 days of
purchase. If you do not register the product with us within the 28 day period,
your product is guaranteed for 1 year only. To validate your extended
warranty, please visit
www.towerhousewares.co.uk and register
with us online. Please note that length of extended warranty offered is
dependent on product type and that each qualifying product needs to be
registered individually in order to extend its warranty past the standard 1
year. Extended warranty is only valid with proof of purchase or receipt. Your
warranty becomes void should you decide to use non Tower spare parts. Spare
parts can be purchased from
www.towerhousewares.co.uk
Should you have a problem with your appliance, or need any spare parts, please
call our Customer Support Team on: +44 (0) 333 220 6066
Call us first, we can help. With advice, spares and returns.
Visit our website:towerhousewares.co.uk
Call: +44 (0)333 220 6066
(8.30am to 6.00pm Monday-Friday)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>