HoverBar Tower 12S Duo Adjustable Stand for iPad Owner’s Manual
- June 3, 2024
- HoverBar Tower
Table of Contents
owner’s guide
What’s in the Box
(a) Tower Post Poles (3)
(B) Weighted Base
© Articulating Arm with Ridged Collar
(D) iPad Clip
(E) iPad Clip Collar (attached to iPad Clip)
Assembly Instructions (no tools required)
-
Carefully remove all parts from the box and packaging.
Assemble the Tower Post by screwing the three segments firmly together.
-
Carefully screw the Tower Post into the Weighted Base. Once tightened, firmly grasp the bottom segment of the Tower Post and give a final, strong twist to make sure there is no movement between the Tower Post and Weighted Base
-
Unfold the Articulating Arm by firmly grasping the body and pull each stalk outward approximately to the positions shown below.
-
Attach the Articulating Arm to the Tower Post by carefully aligning the threads and screwing the Articulating Arm onto the Tower Post. Once hand-tight, give a last firm twist to the Ridged Collar of the Articulating Arm.
Note: For maximum stability, point the bottom segment of the Articulating Arm towards the back of the Weighted Base.
-
Attach the iPad Clip to the Articulating Arm by removing the iPad Clip Collar and sliding it on to the ball of the Articulating Arm. Firmly press the iPad Clip onto the ball of the Articulating Arm until it snaps into place, and then tighten the collar back onto the iPad Clip.
Note: Do not over-tighten.
Securing iPad
- Insert the edge of the iPad into one side of the iPad Clip and pull the clip open with the other hand.
- When the top of the iPad Clip is expanded beyond the top edge of the iPad, lean the iPad back into the iPad Clip.
- Carefully release the iPad Clip to secure the iPad in place.
- Rotate and position the iPad into the desired placement and orientation.
Note: Please remove the iPad from the iPad Clip when significantly repositioning the HoverBar Tower or moving it.
HoverBar Tower Tips & Tricks
To prevent your iPad from tilting out of position, gently but firmly tighten
the iPad Clip Collar. Do not over-tighten. 
You can use HoverBar Tower with your iPhone. Just insert the iPhone
into the iPad Clip horizontally.
If a shorter height is desired, HoverBar Tower can be assembled with only two
Tower Post segments instead of three. 
Use two hands to adjust Articulating Arm.