SEALEY SFF16 16” 3-SPEED DESK/FLOOR FAN 230V User Guide
- June 4, 2024
- SEALEY
Table of Contents
16” 3-SPEED DESK/FLOOR FAN 230V
MODEL NO: SFF16
Thank you for purchasing a Sealey product. Manufactured to a high standard,
this product will, if used according to these instructions, and properly
maintained, give you years of trouble-free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE
OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT IS CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
|
---|---
Refer to instruction manual| Indoor use only
SAFETY
1.1. ELECTRICAL SAFETY
WARNING! It is the user’s responsibility to check the following:
Check all electrical equipment and appliances to ensure that they are safe
before using. Inspect power supply leads, plugs and all electrical connections
for wear and damage. Sealey recommends that an RCD (Residual Current Device)
is used with all electrical products. You may obtain an RCD by contacting your
local Sealey stockist.
if the product is used in the course of business duties, it must be maintained
in a safe condition and routinely PAT (Portable Appliance Test) tested.
Electrical safety information, it is important that the following information
is read and understood.
1.1.1. Ensure that the insulation on all cables and on the appliance is safe
before connecting it to the power supply.
1.1.2. Regularly inspect power supply cables and plugs for wear or damage and
check all connections to ensure that they are secure.
1.1.3. Important: Ensure that the voltage rating on the appliance suits
the power supply to be used and that the plug is fitted with the correct fuse
– see fuse rating in these instructions.
DO NOT pull or carry the appliance by the power cable.
DO NOT pull the plug from the socket by the cable. Remove the plug from
the socket by maintaining a firm grip on the plug.
DO NOT use worn or damaged cables, plugs or connectors. Ensure that any
faulty item is repaired or replaced immediately by a qualified electrician.
1.1.4. This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch the electricity supply and
remove from use.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact
a qualified electrician.
Class II products are wired with live (brown) and neutral (blue) only are
marked with the Class II symbol;
A) Connect the BROWN live wire to the live terminal ‘L’.
B) Connect the BLUE neutral wire to the neutral terminal ‘N’.
C) After wiring, check that there are no bare wires and ensure that all wires
have been correctly connected.
Ensure that the cable outer sheath extends inside the cable restraint and that
the restraint is tight.
DO NOT connect either wire to the earth terminal.
Sealey recommends that repairs are carried out by a qualified electrician.
If an extension reel is used it should be fully unwound before connection. A
reel with an RCD fitted is preferred since any appliance plugged into it will
be protected. The cable core section is important and should be at least
1.5mm², but to be absolutely sure that the capacity of the reel is suitable
for this product and for others which may be used in the other output sockets,
we recommend the use of 2.5mm² section cable.
1.2. GENERAL SAFETY
9 Disconnect the fan from the mains power when not in use and before servicing
or performing any maintenance.
9 Use the fan in dry areas only. DO NOT use in wet or areas with high
condensation such as showers, pools etc.
WARNING! If a fan falls into water or other liquid, immediately switch
off and disconnect from the mains power supply. DO NOT touch the fan until
the mains power supply has been disconnected.
Always disconnect the fan from the power supply when moving it from one
location to another and ensure fan is stood on a level surface.
The fan air flow is powerful. Before use ensure that there is nothing nearby
that will be damaged or displaced by the stream of air.
Keep the fan clean and maintained in good condition. For motor service contact
an authorised service agent.
Use recommended parts only. Unapproved parts may be dangerous, and will
invalidate your warranty.
DO NOT operate the fan where there are explosive or flammable gases, fumes
or other hazardous substances.
DO NOT stand the fan on the power cable.
DO NOT insert any objects through the fan guard.
DO NOT cover the fan when in use.
DO NOT immerse the fan in water or any other liquid.
DO NOT allow children to operate the fan.
DO NOT stand the fan where it may be knocked over or off a surface, or
where the lead may cause a person to trip.
DO NOT modify speed control or attempt to fit any additional external
speed control device to the fan.
When not in use place the fan in its original box or cover to protect from
dust and store in a safe, dry, childproof location.
NOTE: This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
INTRODUCTION
Manufactured from durable composite material, ergonomically designed to pivot on a 180° axis, maximizing the volume and direction of airflow. Can also be wall mounted. Features 3 speed settings, which can ideally be used for intense cooling power or as an air circulator for the whole room. Fitted with BS fully approved plug.
SPECIFICATION
Model No: …………………………………………………………. SFF16
Fan ø: ……………………………………………………… 400mm (16”)
Speeds: ……………………………………………………………………. 3
Power: ………………………………………………………………..42.5W
Supply: …………………………………………………………………230V
Height: …………………………………………………………….. 525mm
Maximum Flow Rate (F): ………………………………….. 22m³/min
Fan Power Input (P): …………………………………………… 42.5W
Service Value (SV): ………………………………… 0.5 (m³/min)/W
Standby Power Consumption (Psb): …………………………0.0W
Fan Sound Power Level (Lwa): …………………………… 63dB(A)
Maximum Air Velocity (c): …………………………………… 3.47m/s
SFF16
Directive/Regulation:| | Energy Label. Fan.
NOT APPLICABLE
---|---|---
Directive/Regulation:| | Ecodesign Fan.
206/2012/EU: ≤ 125W
327/2011/EU: input between 125W and 500W
Report Reference:| 4343696.52| Date: 09/03/2018
Test house:| DEKRA
206/2012/EU: (Fan ≤ 125W)| one decimal place ^to nearest whole number
Maximum fan flow rate F. m³/min| 22.0|
Fan power input, P. W| 42.5|
Service value, SV. (m³/min/W| 0.5|
Standby power consumption, P Watt SB| 0|
Fan sound power level, LWA dB(A)| 63| ^
Maximum air velocity, c.meters/sec| 3.47|
Measurement standard for service value| IEC 60879:1986|
OPERATION
4.1. The fan can be used either free-standing or wall-mounted (fig.1).
4.2. WALL MOUNTING – fig. 1
4.2.1. Unclip both feet, install 2 x 4mm round head screws at 266mm centers in
the required position but do not screw home fully.
4.2.2. Locate the keyhole slots in the fan base over the screw heads and slide
the base down.
4.2.3. Tighten screws down over base, taking care not to over-tighten.
4.2.4. The fan head will lock in 10° increments to allow the most effective
position to be selected (fig.1).
4.3. The fan is supplied with a switch providing ‘off’ and 3-speed settings.
(fig.2)
4.4. When the fan is being used free-standing, ensure that the switch is in
the ‘off’ position before connecting to mains power.
4.5. Ensure that the flex between the mains plug and the fan is routed so as
not to present a trip hazard.
MAINTENANCE
IMPORTANT: Turn the fan OFF and disconnect from the power supply
before cleaning.
5.1. Use only a soft, damp cloth to clean the fan.
DO NOT immerse the fan in water and NEVER allow water to drip into
the motor housing.
DO NOT use solvents or other chemicals to clean the fan.
5.2. To clean the fan blades, remove the front guard by removing the 5 screws
situated on the reverse side of the fan guard.
5.3. Wipe the blades and guards clean then reassemble the front guard.
5.4. When not in use, place the fan in its original box or otherwise cover to
protect it from dust and store in a safe, dry childproof location.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the
EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the
product is no longer required, it must be disposed of in an environmentally
protective way. Contact your local solid waste authority for recycling
information.
Note: It is our policy to continually improve products and as such we
reserve the right to alter data, specifications and component parts without
prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is
required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk.
IP32 7AR
01284 757500
01284 703534
sales@sealey.co.uk
www.sealey.co.uk
© Jack Sealey Limited
Original Language Version
SFF16 Issue 3 (3) 16/12/21
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>