CNBINGO 0-10V Rotary Dimmer Switch Instruction Manual
- June 14, 2024
- CNBINGO
Table of Contents
CNBINGO 0-10V Rotary Dimmer Switch
Thank you
Thank you for purchasing our Mechanical Dimmer Switch
This manual will ensure smooth and comfortable use. Please read the instructions carefully before usage.
TECHNICAL DATA
| Dimensions | 86 x 86 x 45.5 mm |
|---|---|
| Working voltage | 220V AC / 50 – 60 Hz |
| Load | resistive load 500W, LED load 80W |
| Distance between the screws | 58 – 62 mm |
| Mechanical Lifespan | 10 0 ,00 0 switching cycles |
ATTENTION
- Never try to mount the light switch on your own. Only have the installation carried out by a trained specialist!
- The light switch cables must be connected exactly as in the following graphic.
- Make sure that all cables are sufficiently isolated.
- Make sure that there is no voltage and the electric power is turned off by powering off the fuse.
- The diameter of the flush-mounted box must be at least 72mm and the depth must be at least 65mm.
MOUNTING
Before the light switch can be mounted you have to power off the fuse so hat there is no electric power.
-
Remove the glass panel of the switch by using a screwdriver.
-
Unscrew the screws slightly and connect the cables as shown in the circuit diagram. Tighten the screws again and make sure that no cables are loose, and the isolation of the wires reaches the housing.
-
Mount the light switch to your flush-mounted box by using the delivered screws.
-
Hook the glass panel back into the housing and press it until you hear a click and the panel is firmly seated on the housing.
Make sure that the panel is mounted to the housing the right way around. The cable connections should point upwards and the groove should be on the bottom of the glass panel.
- Now, the fuse can be powered on again.
USAGE OF THE SWITCH
- Light will brighten if turn the button clockwise.
- Light will dim down if turn the button counter clockwise.
- There is “click” sound when turn on or off.
HINTS
- The lamps to be used must have a minimum power of 3 W triac dimmable lamp.
- Protect the device from humidity and moisture.
- Do not use near water.
- Avoid bumps or falls.
- Do not try to modify the unit or to repair it by yourself.
- Clean only with a dry cloth. Do not use chemical substances.
- Do not dispose of the device in household waste at the end of its life cycle.
Only dispose at specially-designated collection locations, recycling depots or disposal companies.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>