CNBINGO 110 Touch Light Switch Instruction Manual

CNBINGO 110 Touch Light Switch

Thank you for purchasing our Touch Light Switch

This manual will ensure smooth and comfortable use. Please read the instructions carefully before usage.

TECHNICAL DATA

Dimension

ATTENTION

• Never try to mount the light switch on your own. Only have the installation carried out by a trained specialist!
• The light switch cables must be connected exactly as in the following graphic.
• Make sure that all cables are sufficiently isolated.
• Make sure that there is no voltage and the electric power is turned off by powering off the fuse.
• The diameter of the flush-mounted box must be at least 72mm and the depth must be at least 65mm.
• Do not remove the protective film of the touch surface that is located inside the light switch (underneath the cover) to prevent loss of sensitivity.
• The light switch does not work with lamps that have inductive ballasts.

Note:
A capacitor or LED adapter is necessary when the lamp flashes or cannot be completely off.

Mounting:
Before the light switch can be mounted you have to power off the fuse so that there is no electric power.

• Remove the glass panel of the switch by using a screwdriver.
• Unscrew the screws slightly and connect the cables as shown in the circuit diagram. Tighten the screws again and make sure that no cables are loose, and the isolation of the wires reaches the housing.
• Mount the light switch to your flush-mounted box by using the delivered screws.
• Hook the glass panel back into the housing and press it until you hear a click and the panel is firmly seated on the housing.
• Make sure that the panel is mounted to the housing the right way around. The cable connections should point upwards and the groove should be on the bottom of the glass panel.
• Now, the fuse can be powered on again.

Usage of the switch

• To turn on the light, touch the circle in the center of the switch.
• If the circle shines in blue, it means that the light is turned on.

TROUBLESHOOTING

• The lamps to be used must have a minimum power of 3 W.
• The switch automatically detects if there is a load. If no light at all or a defective light is connected, the switch cannot be turned on.
• If the switch has a malfunction during use, you can reset it by disconnecting the power supply for approximately 10-15 minutes.

HINTS

• Protect the device from humidity and moisture.
• Do not use near water.
• Avoid bumps or falls.
• Do not try to modify the unit or repair it by yourself.
• Clean only with a dry cloth. Do not use chemical substances.
• Do not dispose of the device in household waste at the end of its life cycle.

Only dispose of at specially designated collection locations, recycling depots, or disposal companies.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>