AVATAR SD201-3SH Drum Kit Installation Guide

Drum Kit
Installation Manual V1.20

IMPORTANT NOTES ****

Please observe the following notes, but not limited to these notes!

• Do not place the kit under direct sunlight, near radiate heat devices, or otherwise subject to temperature extremes. Excessive heat can deform or discolor the kit.
• When moved from one location to another where the temperature and/or the humidity is very different, before the use, you must allow it to stand for hours until the condensation has completely evaporated.
• The unit is sensitive to electromagnetic signals, so please don’t use the unit close to devices that have high electromagnetic interference such as TV, radio, remote-controlled toys, etc.
• Please don’t wash the mesh head with any corrosive or detergent. In case of smudge, you can take off the mesh head from the pad and flush with clear water, and then use it when it is absolutely dry.
• Please use the specified power adapter. The use of the wrong adapter may cause damage of the kit.
• Please must make sure well-grounded connection.
• Do not open the unit and analyze the parts. Do not make any changes to any internal parts. The unit has no parts repairable for users. Any functional wrong or damaged, please deliver to the qualified repairing persons.
• The parts such as pads and mesh head are specified for avatar drum, please do not privately take replacement with others. Please only consult to dealers or distributors

INSTALLATION INSTRUCTIONS

1. Installing tools
   (1) a Knife（Provided by user), to gash the box tapes.
   (2) Drum Key (Please find it in the bag of drumsticks), to install racks and just pads.

2. STEPS：

3. Open the box with a knife and take out of all the parts as below picture. Count them below List.
   

4. Assemble the racks as below pictures， fastening the screw after the assembly.
   Note: Please make sure the rack reaches the position as ① shown.
   

5. Fix the Hi-Hat.
   

6. Fix the Bass Drum.
   

7. Fix the drums.
   

8. Fix the cymbals.
   Note: Please put the groove of the cymbal against the embossment of the stand.

9. In the end, connect the module and pads and cymbals with signal lines, and adjust the parameters of the module to be suitable. (Please refer User Guide for adjusting the module)

Notice: Please install the kit and connect lines under power blackout!

1. Drum Module
2. Hi-Hat
3. Hi-Hat Controller
4. Crash 1
5. 8” Tom 1
6. 8” Tom 2
7. Ride| 8. Crash 2
9. 10” Tom 3
10. 10” Snare
11. Bass Drum
12. Bass Pedal
13. Hi-hat pedal
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>