REMINGTON F4002 Foil Shaver Instruction Manual

Style Series Foil Shaver
F4
remington-europe.com

F4002 Foil Shaver

Thank you for buying your new Remington® product. Please read these instructions carefully and keep them safe. Remove all packaging before use.

IMPORTANT SAFEGUARDS

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.

• Always check the appliance before you use it. Do not use the appliance if it is damaged, as this may cause injury.

• The adaptor contains a transformer. Do not cut off the adaptor to replace it with another plug, as this causes a hazardous situation.
  Suitable for use in a bath or shower.

• WARNING: Detach the device from the charging adapter before cleaning it in water.

• Do not use the product with a damaged cord. A replacement can be obtained via our International Service Centres.

• WARNING: For recharging the battery, only use the charger supplied with the appliance – type reference PA-0505K.

• Always replace a damaged adaptor with one of the original type.

• Do not use the appliance if it is damaged or malfunctions.

• Do not use attachments other than those we supply.

• This appliance should never be left unattended when plugged into a power outlet, except when charging.

• Keep the power plug and cord away from heated surfaces.

• Do not plug or unplug the appliance with wet hands.

• Do not twist or kink the cable, or wrap it round the appliance.

• This appliance is not intended for commercial or salon use.

PARTS

1. On/off switch
2. Foil screens
3. Cutter assembly
4. Charging indicator lights
5. Hairpocket
6. Power port| 7. Pop-up trimmer
8. Stubble head guard
Not shown:
9. Adaptor
10. Cleaning brush
---|---

GETTING STARTED

CHARGING YOUR SHAVER

1. Ensure the product is switched off.
2. Connect the shaver to the adapter and then to the mains.

CHARGING INDICATOR

• Run time from fully charged is up to 50 minutes.
• Charge time from empty is 4 hours.
• To preserve the life of your batteries, let them run out every 6 months then recharge for 24 hours.

INSTRUCTIONS FOR USE

It is recommended that you use your new shaver daily for up to four weeks to allow time for your beard and skin to become accustomed to the new shaving system.

SHAVING

1. Switch the shaver on by pressing the on/off switch.
2. Stretch the skin with your free hand so the hairs stand upright.
3. Hold the shaving head so that the foils touch your face.
4. Use short, linear strokes.

TRIMMING

1. Push the trimmer release button up to activate the trimmer.
2. Hold the trimmer at a right angle to your skin.
3. To retract the trimmer, slide the trimmer release button down and push the back of the trimmer head downwards until it locks into place.

STUBBLE LOOK
Fit the stubble head guard to your shaver for a 3-day stubble look.

TIPS FOR BEST RESULTS

• Always hold the shaver at right angles to the skin so that all foils are touching the skin with equal pressure.
• Use moderate to slow stroking movements. The use of short linear motions in stubborn areas may obtain a closer shave, especially along the neck and chin line.
• DO NOT press hard against the skin in order to avoid damage to the foil heads.

CARE FOR YOUR SHAVER

Care for your appliance to ensure a long lasting performance. We recommend you clean your appliance after each use.
The easiest and most hygienic way to clean the appliance is by rinsing the appliance head after use with warm water.

1. Remove the shaver head (pull the head up and off FIG A).
2. Tap out the excess hair shavings and rinse the foils under running water (Fig B, C).
3. Do not clean the shaving foil with a brush.
4. Replace the head assembly by placing the assembly on top of the hair pocket, press down and click into place.
   • Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil.

REPLACING THE FOILS AND CUTTERS

To ensure continued high quality performance from your shaver, we recommend the foils and cutters are replaced every six months.

SIGNS THAT YOUR FOILS AND CUTTERS NEED REPLACING.

• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may feel the cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.

TO REPLACE THE FOIL

1. Remove the shaver head (pull the head up and off FIG A).
2. Fit the new foil assembly over the hair pocket and press down to click into place.

REPLACING THE CUTTERS

1. Grasp the cutter between your thumb and forefinger and pull upwards.
2. Snap the new cutter into the oscillator tip. Note: DO NOT press on the cutter ends as this may cause damage.
3. Foil head replacements can be found on the Remington website.

BATTERY REMOVAL

We strongly recommend that a professional removes the rechargeable battery. Parts of the shaver case, and tools have sharp edges and may cause injury if not handled correctly.

• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.

1. Pry off the two decorative side panels.
2. Unscrew one screw from the bottom of the shaver and remove the bottom panel.
3. Remove the foil assembly and unscrew the 4 screws underneath it.
4. Remove the two E-rings one on each side of the head then lift off the upper head assembly.
5. Unscrew the 2 screws below the upper head assembly then lift the rest of the head off the body.
6. Pry off the upper decorative panel to expose 2 screws. Remove the screws.
7. Remove the front panel to expose 4 screws. Remove the 4 screws then remove the back housing.
8. Lift out the battery and printed circuit board assembly.
9. Disconnect the battery from the circuit board.
   • The battery is to be disposed of safely.

ADAPTER SPECIFICATIONS

Manufacturer address and registration number| Spectrum Brands (UK) Limited, Regent Mill, Fir Street,
Failsworth, Manchester M35 0HS
Company number: 02394603
---|---
Adapter model number| PA-0505K
Input voltage| 100 – 240 V~
Input AC Frequency| 50/60Hz
Output voltage| 5.0 V
Output current| 0.5 A
Output power| 2.5 W
Average active efficiency| ≥73.16%
Efficiency at 10%| –
No load power consumption| ≤0.1W

RECYCLING

To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/collection point.

Ref. No. F4002
Type No. F24A

23/INT/ F4002 T22-7002852 Version 01 /23
Remington® is a Registered Trade Mark of Spectrum Brands,Inc., or one of its subsidiaries
Russell Hobbs Deutschland GmbH, Am Unisyspark 1, 65843 Sulzbach, Germany remington-europe.com
© 2023 Spectrum Brands, Inc.

References

• Remington - EST. NEW YORK 1937 | Haircare & Personal Care Appliances for Men & Women

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>