Enerlites 61501-2C3 Dual USB Type-C Charger TR Receptacle Instruction Manual
- June 14, 2024
- ENERLITES
Table of Contents
**Enerlites 61501-2C3 Dual USB Type-C Charger TR Receptacle Instruction Manual
**
SPECIFICATION
Receptacle Rating: 15Amp. 125VAC, 60Hz
USB Rating: Two USB ports: Type C USB Ports 5V/3A
Wire Terminals: #14-#12AWG
Operating Temperature: -4 to 140°F (-20 to 60°C)
Receptacle Dimension: 3-3/4″x2-1/4″x3-3/16″
DESCRIPTION
The 61501-2C3 USB Charger/Tamper-Resistant Receptacle offers two type C charging port and duplex Tamper-Resistant Receptacles. This device is able to deliver the optimum current accordingly to the device types and models attached, and charge any two devices up to 3.6 Amp charging capacity simultaneously, including smart phones, tablets. The USB Type C port are reversible and no up or down orientation. The receptacle is back and side wired for broad compatibility with diverse wiring needs. The product can fit in any standard in-wall outlet box
FEATURE
- 15A Tamper-Resistant receptacle
- Each Type C USB Port 5V/3A, combined total 3.6A
- Over-current protection help protect electronics
- Smart chip recognizes device and optimizes charge
WARNING
Turn the power off at the circuit breaker before installing the receptacle.
Read and understand these instructions before installing. This device is
intended for installation in accordance with the National Electric Code and
local regulations. It is recommended that a qualified electrician performs
this installation. Make sure to turn off the circuit breaker or fuse(s) and
make sure power is off before wiring the device.
Use copper wire only
This surge receptacle CANNOT be used if the outlet you are replacing has
the top and bottom outlets controlled by separate circuit breakers.
WIRING DIRECTIONS
There are two ways to wire the receptacle:
-
Loop wire around terminal screws and firmly tighten terminal screw.
OR -
Insert wire(s)through terminal holes in the back, then tighten terminal screws. Use this method when attaching 2 wires to same terminal.
- Connect HOT wire to the HOT terminal ( brass screw)
- Connect NEUTRAL wire to the NEUTRAL terminal(silver screw)
- Connect GREEN or BARE wire to the GROUND terminal(green screw)
COMPATIBILITY
This High Speed USB Charger/Tamper-Resistant Receptacle is compatible with a wide range of electronic devices including, but not limited to, the following
- Tablets
- Mobile Phones
- Bluethooth Headsets
- Digital Cameras
- Nook e-reader
- GPS Devices
- HTC One X9
- HTC One S9
- Nexus 6P • Lenovo ZUK Z1
- Samsung Galaxy S4 Samsung Galaxy Note 3 Samsung Galaxy J7™
- Other Smart Phones and USB Compatible products
To replace the USB face cover, use a flaz screwdriver to pry-off the cover.
WARRANTY INFORMATION
This device is warranted to be free of material and workmanship defects for 2 years from the date of purchase. Original receipt or proof of purchase from an authorized retaller must be presented upon warranty claim. ALL claims must be verified and approved by Enerlites, Inc: Warranties from other Enerlites products may vary. This warranty is nontransferable and does not cover normal wear and tear or any malfunction, failure, or defect resulting from misuse, abuse, neglect, alteration, modification, or improper installation. To the fullest extent permitted by the applicable state law. Enerlites shall not be able to the purchaser or end user customer of Enerites products for direct, indirect incidental, or consequential damages even if Enerlites has been advised of the possibility of such damages. Enerlites total liability under this or any other warranty, express or implied, is limited to repair, replacement or refund Repair, replacement or refund are the sole and exclusive remedies for breach of warranty orany other legal theory.
© 2022 Enerlites Inc.
CA, U.S.A.
WWW.ENERLITES.COM
0205220196
REV 20230804
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>