ENERLITES 61501 Tamper Resistant Receptacle Instruction Manual
- June 14, 2024
- ENERLITES
Table of Contents
INSTALLATION INSTRUCTIONS 61501-1A1C-PD30
30W Type-C USB Power Delivery Charger with
Tamper-Resistant Receptacles
SPECIFICATIONS
Receptacle rating………………………………………………15Amp, 125VAC, 60Hz
USB rating……………………………………………Type A : 5V/9V,3A 12V,2.5A
…………………………………………….Type C : 5V/9V,3A 12V,2.5A
…………………………………………………………….PPS: 3.3V-12V,2.5A
Type A and Type C output…………………..Type A: 5V,2.4A Type C: 5V,3A
Wire terminals……………………………………………………………….#14–#12 AWG
Operating temperature……………………………………..-4 to 140°F (-20 to 60°C)
Receptacle dimension ………………………………………..3-3/4”×2-1/4”×3-3/16”
DESCRIPTION
Enerlites 61501-1A1C-PD30 in wall Charger meets the charging needs of multiple high-demand devices, like your MacBook Pro 16″, iPad Pro (2018), and iPhone 13 series. With 30W USB-C power output, this power delivery fast charger can power the connected device at maximum speeds, freeing you from the need for an adapter and low battery anxiety.
FEATURES
- 30W Power Delivery (PD) 3.0 single port USB-C Charging power. This USB-C receptacle charger takes advantage of Power Delivery in this new era of fast charging, pumping out high wattage of up to 30W, significantly shortening charging time for larger PD-enabled devices like tablets, laptop computers and more.
- Type A provide up to 30W provides up to 4x faster speed than conventional charging.
- 2 shared power USB ports (1 (30W) + 1PD 30W) up to a 30W max output total, charge single device with full speed.
- Cleverly distributes 30w of power between 2 devices when charging simultaneously and supports high-speed charging up to 30W when a single USB-C device is connected.
- Use a USB-C to Lightning cable for Lightning devices and use a USB-C to USB-C cable for USB-C devices (cables not included)
WARNING
Turn the POWER OFF at the circuit breaker before installing the receptacle.
Read and understand these instructions before installing.This device is
intended for installation in accordance with the National Electric Code and
local regulations.It is recommended that a qualified electrician performs this
installation. Make sure to turn off the circuit breaker or fuse(s) and make
sure power is off before wiring the device. Use copper wire only.
This USB receptacle CANNOT be used if the outlet you are replacing has the top
and bottom outlets controlled by separate circuit breakers.
WIRING DIRECTIONS
- Turn off power at circuit breaker.
- Identify the HOT, NEUTRAL, and GROUND wires in the wall box.
- Insert wires into the terminal holes on the back side of the receptacle, then tighten the terminal screws to clamp wires in place.
COMPATIBILITY
30W Type-C Power Delivery with PPS
You can now safely charge or power your electronics with up to 30 watts
Programmable Power Supply (PPS).
USB Type-C Power Delivery provides cooler, faster, and a broader range of
charging. It is compatible with a wide range of electronic devices including,
but not limited to Apple and Android devices. It is backwards compatible with
USB 1.0, 1.1, 2.0, 3.0, and 3.1.
When the charger charges only one device:
USB-C Output: 5V/9V @ 3A, PPS 3.3-12V @ 2.5A (Max 30w)
USB-A Output: 5V/9V @ 3A, 12V @ 2.5A (Max 30w)
Be sure to use quality USB cables because the cable used will effect the speed
of charging. We recommend the use of cables that are capable of 100W for
maximum performance.
© 2022 Enerlites Inc. CA, U.S.A.
WWW.ENERLITES.COM
0202220191-01
REV 20230804
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>