Enerlites 61000 TR3USB-CC Series Triple USB Charger 5.8A w 20A TR Receptacles Instruction Manual
- June 14, 2024
- ENERLITES
Table of Contents
Enerlites 61000 TR3USB-CC Series Triple USB Charger 5.8A w 20A TR
Receptacles
Product Information
- Product Name: 61501/62001-TR3USB-CC
- Product Type: Tamper Resistant Duplex Receptacles with Three Ultra High Speed USB Charger Ports
Product Usage Instructions
- Before installing the receptacle, turn off the power at the circuit breaker.
- Read and understand the installation instructions before proceeding.
- Ensure that the circuit breaker or fuse(s) are turned off and that power is off before wiring the device.
- Use copper wire for wiring.
- If the outlet being replaced has the top and bottom outlets controlled by separate circuit breakers, this USB receptacle cannot be used.
- To replace the USB face cover, use a flat screwdriver to pry off the bottom left and right.
SPECIFICATIONS
- Receptacle Rating …………………………………………………………..15/20 Amp, 125VAC
- USB Rating …………………………………….Three USB ports with total 5.8 Amp, 5VDC
- Wire Terminals ……………………………………………………………………….#14–#12 AWG
- Operating Temperature ……………………………………………. -4 to 140°F (-20 to 60°C)
- USB Compatibility ……………….. USB 1.1/2.0/3.0 devices, including Apple products
- Receptacle Dimension …………………………………………………..3-3/4”×2-1/4”×3-3/16”
DESCRIPTION
61501/62001-TR3USB-CC is the Industry’s first 5.8A, 5VDC triple USB charger with duplex 15/20A tamper resistant receptacle. Our High Speed USB ports deliver the most advanced charging technology and optimize current by using a smart chip to reduce charging time to devices. The USB charger receptacle gives you the ability to charge virtually any device without the use of bulky adapters that can be lost or misplaced, while continuing to power traditional appliances, e.g. lamp or television with the same receptacle.
FEATURES
- Industry’s first triple USB High Speed charger at 5.8 Amp, 5VDC
- Charges most USB compatible devices directly without an adapter
- 2011 NEC Code compliant Tamper-Resistant Shutters
- Replaces a standard duplex receptacle
- Interchangeable Face Cover
- Wire terminals are designed for easy installation from the back or side
- UL Listed
WARNING
- Turn the POWER OFF at the circuit breaker before installing the receptacle.
- Read and understand these instructions before installing. This device is intended for installation in accordance with the National Electric Code and local regulations. It is recommended that a qualified electrician performs this installation. Make sure to turn off the circuit breaker or fuse(s) and make sure power is off before wiring the device.
- Use copper wire only.
- This USB receptacle CANNOT be used if the outlet you are replacing has the top and bottom outlets controlled by separate circuit breakers.
WIRING DIRECTIONS
There are two ways to wire the receptacle:
- Loop wire around terminal screws and firmly tighten terminal screw.
- Insert wire(s) through terminal holes in the back, then tighten terminal screws. Use this method when attaching 2 wires to same terminal.
- Connect HOT wire to the HOT terminal (brass screw).
- Connect NEUTRAL wire to the NEUTRAL terminal (silver screw).
- Connect GREEN or BARE wire to the GROUND terminal (green screw).
COMPATIBILITY
This USB Charger/Tamper-Resistant Receptacle is compatible with a wide range
of electronic devices including, but not limited to, the
following:
- iPad®Pro
- iPad®Air
- iPad® Mini
- iPod®
- iPhone ® 6/ 6 Plus
- Tablets
- Mobile Phones
- Bluethooth” Headsets
- Digital Cameras
- HTC One X9™
- HTC One S9™
- Samsung Galaxy S
- Samsung Galaxy Note 3™
- Samsung Galaxy J7
- Galaxy Tab™
- Other Smart Phones and USB Compatible products
WARRANTY INFORMATION
This device is warranted to be free of material and workmanship defects for 2 years from the date of purchase. Original receipt or proof of purchase from an authorized retailer must be presented upon warranty claim. ALL claims must be verified and approved by Enerlites, Inc. Warranties from other Enerlites products may vary. This warranty is nontransferable and does not cover normal wear and tear or any malfunction, failure, or defect resulting from misuse, abuse, neglect, alteration, modification, or improper installation. To the fullest extent permitted by the applicable state law, Enerlites shall not be liable to the purchaser or end user customer of Enerlites products for direct, indirect, incidental, or consequential damages even if Enerlites has been advised of the possibility of such damages. Enerlites’ total liability under this or any other warranty, express or implied, is limited to repair, replacement or refund.Repair, replacement or refund are the sole and exclusive remedies for breach of warranty or any other legal theory.
© 2019 Enerlites Inc.
CA, U.S.A.
WWW.ENERLITES.COM
0212160066-04
REV 20230803
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>