Enerlites 17001-F3 3-Speed Fan and Full Range Dimmer Instruction Manual
- June 14, 2024
- ENERLITES
Table of Contents
Enerlites 17001-F3 3-Speed Fan and Full Range Dimmer
SPECIFICATIONS
- Voltage ……………………………………………………………………………………………………120 VAC 60Hz
- Load rating -3 Speed Fan …………………………………………………………………………………………2.5A
- Incandescent ………………………………………………………………………………………………….360W Max
- LED ……………………………………………………………………………………………………………….150W Max
- Operating Temperature ………………………………………………………………………………….32°F-104°F
DESCRIPTION/ FEATURES
The 17001-F3 by Enerlites is a combination of a 3-speed fan control and a fully variable dimmer in one. The fan control will work with “pull-string” type fans, but is not compatible with fan types that use remotes or other digital controls. The dimmer is compatible with LED, CFL, incandescent, and halogen bulbs. DO NOT USE WITH LOW-VOLTAGE BALLASTS OR DRIVERS.
Other features:
- Replace standard switches with 17001-F3 for easy fan speed and light-dimming control without having to reach for the pull string
- Provides 3-speed control for ceiling fan with a slide control that stops at each speed
- Suitable for multi-gang installations
- Simple slide control lever to fade lighting up and down smoothly
WARNING
Turn the POWER OFF at the circuit breaker before installing Read and understand these instructions before installing. This device is intended for installation by the National Electric Code and local regulations. It is recommended that a qualified electrician perform this installation. Make sure to turn off the circuit breaker or fuse(s). DO NOT CONNECT NEUTRAL WIRES TO THIS CONTROLLER Use copper wire only
“CAUTION – To Reduce The Risk of Overheating and Possible Damage to Other Equipment, Do Not Install to Control a Receptacle, a Motor-Operated Appliance a Fluorescent Light Fixture or a Transformer Supplied Appliance”
WIRING
- Turn Off the Circuit Breaker
- Connect the HOT wire to the BLACK wire on the switch.
- Connect the FAN wire to the BROWN wire on the switch.
- Connect the LIGHT wire to the RED wire on the switch.
- Connect the GROUND wire to the GREEN wire on the switch.
- Mount the Fan Speed Control to the box with the “UP” indicator pointing up.
- Turn on Circuit Breaker.
OPERATION
WARRANTY INFORMATION
This device is warranted to be free of material and workmanship defects for 2 years from the date of purchase. An original receipt or proof of purchase from an authorized retailer must be presented upon warranty claim. ALL claims must be verified and approved by Enerlites, Inc. Warranties from other Enerlites products may vary. This warranty is non-transferable and does not cover normal wear and tear or any malfunction, failure, or defect resulting from misuse, abuse, neglect, alteration, modification, or improper installation. To the fullest extent permitted by the applicable state law, Enerlites shall not be liable to the purchaser or end-user customer of Enerlites products for direct, indirect, incidental, or consequential damages even if Enerlites has been advised of the possibility of such damages. Enerlites’ total liability under this or any other warranty, express or implied, is limited to repair, replacement or refund. Repair, replacement or refund are the sole and exclusive remedies for breach of warranty or any other legal theory.
2016 Enerlites Inc. CA, U.S.A. WWW.ENERLITES.COM 0209190145-01 REV 20230802
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>