Enerlites 17000-F3 3 Speed Fan Control Slider Instruction Manual
- June 14, 2024
- ENERLITES
Table of Contents
Enerlites 17000-F3 3 Speed Fan Control Slider
Product Information
The 17000-F3 Fan Control by Enerlites is a 3-speed fan control designed to conveniently set the speed of a ceiling fan. It is compatible with ceiling fans that have pull-chain controls. This device is intended for installation in accordance with the National Electric Code and local regulations. It is recommended to have a qualified electrician perform the installation.
The fan control has the following specifications:
- Load: Fan
- Power: Hot
- Neutral: Do not connect neutral wires to this controller
- Fan Speed Settings: Low (L), Medium (M), High (H), Off
Installation Instructions:
WARNING:
Before installing, turn the power off at the circuit breaker. Read and
understand these instructions before installing.
CAUTION:
Do not install this controller to control a receptacle, a motor-operated
appliance, a fluorescent light fixture, or a transformer supplied appliance.
WIRING:
- Turn off the circuit breaker.
- Connect the HOT wire to the BLACK wire on the switch.
- Connect the FAN wire to the BROWN wire on the switch.
- Connect the GROUND wire to the GREEN wire on the switch.
- Mount the Fan Speed Control to the box with the UP indicator pointing up.
- Turn on the circuit breaker.
Operation:
To operate the fan control:
- Use the fan control lever to slide to any of the 3 speed settings (L, M, H) or Off to control the fan.
- The lever will have a noticeable stop at each selection.
Warranty Information:
For warranty information, visit www.enerlites.com.
Warranty reference: 0204200155-01 REV 20230802.
SPECIFICATIONS
- Voltage……………………………………………………………………………………………………120 VAC 60Hz
- Load rating – 3 Speed Fan………………………………………………………………………………………..2.5A
- Operating Temperature………………………………………………………………………………….32°F-104°F
DESCRIPTION/ FEATURES
The 17000-F3 Fan Control by Enerlites is designed to conveniently set the speed of a ceiling fan. The ceiling fan control provides convenient operation for fans with pull-chain controls. When installed, simply put your fan on the highest speed setting using the pullchain control and then use the wall control to change the fan speeds and to turn it off.
- Slider provides 3 speeds for fan, and switch turns fan onto preset level
- For use with designer style openings
- Provides 3 quiet fan speeds for comfort
- Easy installation and operation
- For use with indoor ceiling paddle fans only
WARNING
Turn the POWER OFF at the circuit breaker before installing
Read and understand these instructions before installing. This device is
intended for installation in accordance with the National Electric Code and
local regulations. It is recommended that a qualified electrician performs
this installation. Make sure to turn off the circuit breaker or fuse(s).
DO NOT CONNECT NEUTRAL WIRES TO THIS CONTROLLER
Use copper wire only
“CAUTION – To Reduce The Risk of Overheating and Possible Damage to Other Equipment, Do Not Install to Control a Receptacle, a Motor-Operated Appliance a Fluorescent Light Fixture or a Transformer Supplied Appliance”
WIRING
- Turn Off Circuit Breaker
- Connect the HOT wire to the BLACK wire on the switch.
- Connect the FAN wire to the BROWN wire on the switch.
- Connect GROUND wire to GREEN wire on the switch.
- Mount the Fan Speed Control to the box with “UP” indicator pointing up.
- Turn on Circuit Breaker.
OPERATION
WARRANTY INFORMATION
This device is warranted to be free of material and workmanship defects for 2 years from the date of purchase. Original receipt or proof of purchase from an authorized retailer must be presented upon warranty claim. ALL claims must be verified and approved by Enerlites, Inc. Warranties from other Enerlites products may vary. This warranty is nontransferable and does not cover normal wear and tear or any malfunction, failure, or defect resulting from misuse, abuse, neglect, alteration, modification, or improper installation. To the fullest extent permitted by the applicable state law, Enerlites shall not be liable to the purchaser or end user customer of Enerlites products for direct, indirect, incidental, or consequential damages even if Enerlites has been advised of the possibility of such damages. Enerlites’ total liability under this or any other warranty, express or implied, is limited to repair, replacement or refund. Repair, replacement or refund are the sole and exclusive remedies for breach of warranty or any other legal theory.
© 2020 Enerlites Inc.
CA, U.S.A.
- WWW.ENERLITES.COM
- 0204200155-01.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>