WELOV 6L Cool Mist Humidifiers User Guide
- June 14, 2024
- WELOV
Table of Contents
WELOV 6L Cool Mist Humidifiers
TROUBLESHOOTING GUIDE
If you need any further assistance, please feel free to contact us at [email protected]. Failure to keep the humidifier clean and free of mineral deposits may affect the operation of it.
Q1. The water level indicator is off.
| Possible Cause | Solution |
|---|---|
| The humidifier is not plugged in. | Make sure the humidifier is properly |
plugged into a socket.
No power from the power out let.| Try to use other power out lets.
The humidifier is not turned on.| Check if the humidifier has been turned on.
Q2. The low water indicator stays red.
| Possible Cause | Solution |
|---|
No water in the Water Reservoir .
| Make sure the G) Spring is fixed correctly to the bottom of the tank so that water can pass through to the Base.
@ Water Floater was stuck.
| Adjust the@ Water Floater to a horizontal position and make sure it can rise with water.
Q3. The water level indicator is white but there is no or little mist produced.
| Possible Cause | Solution |
|---|
Not enough water inside the tank.
| ****
Refill and place the Water Tank back in place.
Mist level is set too low.
| ****
Adjust the humidifier to the maximum mist.
Mineral build up on the Atomizer .
| Check if any air comes out from t he Nozzle If not, clean water scale on the Atomizer as instructed.
The Base might be overfilled.
| ****
Remove the tank,empty the Ba se , then place the filled tank on the empty Base .
Q4. Tank leakage.
| Possible Cause | Solution |
|---|
Tank may be damaged.
| ****
Check for possible cracks in the tank. If yes please replace it.
Tank Cap is not tightened securely
| ****
Tighten the Tank Cap.
G) Spring was stuck.
| Make sure the G) Spring is fixed correctly to the bottom of the tank so that water can pass through to the Base.
0 Sealing Ring was not installed on installed on the Tank Ca p .
| Make sure the0 Sealing Ring has been Please contact Tank Ca p . Please contact us if it is lost.
Q5: The mist makes the surrounding tables or floors damp. Condensation occurs around humidifiers or on windows/walls.
| Possible Cause | Solution |
|---|
Mist level is set too high for the room size.
| ****
l Check if the room is too humid and adiust the humidifier to alower mist40%-60% works best.
2. Open door and windowsor change to a larger room.
Air Inlet was blocked.
| ****
Make sure the humidifieris placed> 12inches away from the wall.Make sure the Nozzle is not facing the wall or window
Low room temerature leads to liquefaction| ****
Adjust the room temperature to 25°C/77°F.
Q6. The humidification is too poor.
| Possible Cause | Solution |
|---|
Mist level is set too low for the room size.
| lAdiust the humidifier to the maximum mist.
2.Close door or windows to reduce air ventilation,or change to a smaller room.
Air Inlet was blacked .
| ****
Make sure the humidifier is placed a 12 inches away from the wall. Make sure the Nozzle is not facing the wall or window.
---|---
Low room temperature leads to liauefaction.| ****
Adjust the room temperature to 25°°C/77F.
Q7. White dust appears or the black coating on the base flakes off.
| Possible Cause | Solution |
|---|---|
| The tap water may contain too much minerals. | Please replace it with filtered |
or distilled water.
Q8: Strange odor.
| Possible Cause | Solution |
|---|
Please clean the humidifier.
| ****
l Please make sure to clean the humidifier according to the instructions.
2. Leave the empty Water Tank in a cool place for 12 hours without covering Tank Cap
Q9: Strange water noise.
| Possible Cause | Solution |
|---|
Water is going down to the Water Reservoir .
| ****
This is normal while it is working
Q10: Humidifier is getting too hot.
| Possible Cause | Solution |
|---|
The humidifier works for too long.
| ****
Please power it off and put it in a well ventilated place for 10 minutes.
CAUTION
The symbol indicates the DC voltage
RECYCLING
Users should only operate the humidifier once they have understood all the following important safety instructions. Users who have a disability and need assistance are responsible for seeking support and ensuring their safety in line with the instructions given in this manual.
- Children should be supervised to ensure that they do not play with the appliance.
- Unplug the appliance during filling and cleaning.
- Please confirm the composition and quantity of solution to be used during maintenance. If salt is included, it is recommended not to use excessive amounts of solution.
- The appliance is not to be operated from a de-supply. If the supply cord is damaged it must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid a hazard.
- The appliance is only to be used with the power supply unit provided with the appliance.
CUSTOMER SUPPORT
[email protected]
www.welovhome.com