soundcore A3982 Dot 3i V2 True Wireless Earbuds User Manual

: June 14, 2024
: Soundcore

Table of Contents

Important Safety Instructions
Declaration of Conformity
FCC Statement
IC NOTICE TO CANADIAN USERS
Documents / Resources

Important Safety Instructions

Avoid dropping.
Do not disassemble.
Avoid extreme temperatures.
Use original or certified cables.
Do not wear the product while charging.
Do not use any corrosive cleaner or oil to clean.
Do not use the product outdoors during thunderstorms.
Keep out of the reach of children. The product contains small parts which may be a choking hazard.
The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Do not use the product in environments with too high or too low temperatures, and never expose the product to strong sunshine or very wet environments.
Ensure there is no liquid, sweat or water on the charging port when charging.
Refer to your user manual for your earphones’ waterproof level and follow the corresponding instructions.
- For IPX4: Do not expose earphones to dripping or splashing water.
- For IPX4, IPX5, and IPX6: Do not submerge earphones in water.

Hearing Safety

To avoid hearing damage, do not listen for extended periods at high volume.
Do not turn the volume so high that you’re unable to hear your surroundings.
Do not use earphones while driving.
You should use caution or temporarily discontinue use in potentially hazardous situations.

The product generates stronger permanent magnetic fields that could cause interference with cardiac pacemakers, implanted defibrillators (ICDs) and other implants. Always maintain a distance of at least 3.94″/10 cm between the product component containing the magnet (earbuds and charging case) and the cardiac pacemaker, implanted defibrillator, or other implant.
Notice
**** This product complies with the radio interference requirements of the European Community.

Declaration of Conformity

Hereby, Anker Innovations Limited declares that this product is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.soundcore.com.
This product complies with the radio interference requirements of the United Kingdom.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in compliance with Radio Equipment Regulations 2017. The full text of the UK declaration of conformity is available at the following internet address: https://www.soundcore.com.
Maximum output power: 9.0dBm
Frequency band: 2.4G band (2.402GHz-2.480GHz)
This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Follow local rules and never dispose of the product and rechargeable batteries with normal household waste. Correct disposal of old products and rechargeable batteries helps prevent negative consequences for the environment and human health.
This symbol indicates “separate collection” for all batteries and accumulators. Danger of explosion if battery is incorrectly replaced. To reduce risk of fire, explosion or leakage of flammable liquid/gas, don’t disassemble, crush, puncture, short external contacts, expose to temperature above 60°C (140°F), sunshine or like, expose to extremely low air pressure or dispose of in fire or water. Replace only with specified batteries.
High or low extreme temperatures that a battery can be subjected to during use, storage or transportation:

During use: maximum 40℃ (104°F)
Storage: -20 – 45℃ (-4 – 113°F)
Transportation: 5 – 35℃ (41 – 95°F)

FCC Statement

This product complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement
The highest SAR value reported under this standard during product certification for use next to the head with the minimum separation distance of 0mm. This transmitter must not be collocated or operating in conjunction with any other antenna or transmitter.
The following importer is the responsible party.
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1 (800) 988 7973

IC NOTICE TO CANADIAN USERS

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.

CAN ICES-003 (B)/NMB-003 (B)
This Class B digital apparatus complies with Canadian ICES-003.
Radiation Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-102 and had been tested in accordance with the measurement methods and procedures specified in IEEE 1528 and IEC 62209. This equipment should be installed and operated with minimum distance 0mm between the radiator and your head. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
* Additional Legal Rights for Consumers
For consumers, who are covered by consumer protection laws or regulations in their country of purchase or, if different, their country of residence, the benefits conferred by soundcore’s Limited Warranty are in addition to all rights and remedies conveyed by such consumer protection laws and regulations, including but not limited to these additional rights.
For FAQs and more information, please visit https://www.soundcore.com

PAP 22
Raccolta Carta
HPS01
51005003879 V1

Documents / Resources

| soundcore A3982 Dot 3i V2 True Wireless Earbuds [pdf] User Manual
A3982 Dot 3i V2 True Wireless Earbuds, A3982, Dot 3i V2 True Wireless Earbuds, True Wireless Earbuds, Wireless Earbuds, Earbuds
---|---