Sweetcrispy T-LIFT-001 Lift Top Coffee Table Instruction Manual

Sweetcrispy T-LIFT-001 Lift Top Coffee Table

Component List

NOTE:

Bring your own power tools and hammer.

NOTE:

1. As shown, make sure each part is in the correct position.
2. Make sure the gap of the Eccentric Wheel is aligned with the Derrick Screw, and then tighten it completely.

Assembly

Step 1

NOTE

Fix Derrick Screw (A)16 to Board (3), (5), (6)2, (8) as shown.

1. Put a blanket under the board to avoid scratch or damage.
2. Please do not screw Derrick Screw (A) too deep or too shallow.

Step 2

NOTE:

Attach Wooden Pin (B)*10 to Board (3), (5) and (7).
Install Wooden Pin (B) into the inner holes, not the outer holes.

Step 3

Using Bolts (H)*16, install Left Lifter (D) to the pre-drilled holes on the inside of Board (7), and Right Lifter (E) to the pre-drilled holes on the inside of Board (5).

Step 4

With Right Lifter (E) facing down, use Wrench (K) to unscrew the nut at the connection, then lift the damping rod.
Prepare Left Lifter (D) and Board (7) in the same way.

Step 5

Using Bolts (H)*12, install Left Lifter (D) to the “wide” side of Board (9) and Right Lifter (E) to the “narrow” side of Board (9), then lower the damping rod and re-tighten the nut with Wrench (K).

Step 6

With the notched side of Board (6) facing down, install Board (6)2 to Boards (5&7) with Eccentric Wheel (C)8.

NOTE

The screw holes of Board (7) are on the inside and the screw holes of Board (5) are on the outside.

Step 7

As shown, install Board (4) to Board (5), and install Board (3) to Board (4) with Eccentric Wheel (C)*4.

Step 8

Using Wrench (J), install Board (2) to the completed frame with Bolts (I)*10.

Step 9

Using Bolts (H)20, install Solid Wood Foot Connector (G)4 to the four corners of Board (2).

NOTE

The Wooden Foot Connector (G)*4 faces outward.

Step 10

Tighten Wooden Leg (1)4 completely, and glue Silicone Foot Pad (L)4 on the bottom of it.

NOTE

Please wait for 3 minutes until Silicone Foot Pad (L) are completely glued.

Step 11

Attach Board (8) to Boards (3&5).

NOTE

Make sure arrows on Board (9) and Board (8) point to each other.

Step 12

Tighten Eccentric Wheel (C)*4 and make sure Board (8) is fixed.

Step 13

As shown, use Cover-up Sticker (F)*16 to cover the exposed part of bolts.

When lowering and retracting the panel during use, it must be used at the corresponding groove at the bottom of the middle of the panel, and cannot be used on the side, otherwise the hand may be pinched during descent.

Technical Support

(909)637-7665 | (909)637-7593

Other Info
HJ-Customer-Service@outlook.com

Thank you for choosing this product. We strive to provide you with the best quality products and service in the industry. Should you have any issues, please don’t hesitate to contact us.

HJ-Customer-Service@outlook.com

(909)637-7665 | (909)637-7593

EST 9:00AM–17:00PM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>