DREO DR-HEC001 Cooling Fans That Blow Cold Air User Guide
- June 14, 2024
- DREO
Table of Contents
QUICK START GUIDE
When using the appliance for the first time, remove the wraps and attach the parts by following the steps below.
(1)
- Down
- Up
Insert the edge of both base halves into each other.
(2)
Press down on edges to click two base halves together.
(3)
Run the cord through the center hole. and fit the base onto the fan
(4)
Align the screw with the double ended arrow on the underside as shown.
(5)
Rotate the base counterclockwise to lock in place.
(6)
Thread the cord through all REAR cord keepers and put the fan upright.
CAUTION
Do not operate the tower fan if the base has not been installed.
Make sure to thread the cord through all rear cord keepers.
Rev_1.1_EN
Filling the Water Tank
- Press between the recesses on the tank and pull the tank out.
- Press inwards the black tabs on the pump hose attachment to release.
- Add in ice packs (optional), and fill the tank under a water supply, up to the max level.
- Align and lock the tabs back into place.
- Return the water tank to its original position.
Position the cooler with its back faced to an open window or door for best cooling. Note that putting it in an enclosed space will add up humidity in the room, resulting in reduced humidifying/cooling performance.
Extend Warranty to 30 Months
Scan the OR code or visit dreo.com/warranty to
extend your warranty for free.
Looking for help?
Contact us to get expert support.
Fast, professional, helpful.
(888)290-1688
Mon – Fri. 9:00 am – 5:00 pm PST/PDT
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>