LAKEMID LET001BR1 End Table with Charging Station Instruction Manual

End Table
with charging station

LET000BR1
LET000BK1
LET000WT1
LET000NA1

General Guidelines

• Please read the following instruction carefully and use the product accordingly.
• Please keep this manual and hand it over when you transfer the product.
• This summary may not include every detail of all variations and considered steps.
  Please contact us when further information and help are needed.

Notes

• lt is recommended that 2 adults assemble the product using the included tool, Strictly follow the assembly steps.
• lf there is any odor after unpacking, put the product in a ventilated place for several days to air out.
• Ensure all pats are intact before assembly. lf there are any damaged or missing parts, stop assemble and contact us immediately. lt is recommended to assemble the product on a soft surface.
• Loosely tighten screws first, then fully tighten them after you finish the assembly.
• Inspect the tightness of screws regulariy and tighten again if necessary.
• Protect the product from strong sunlight, damp environments, and mildew.
• For daily care, please clean it with a damp cloth first, then wipe dry.

Warnings

• During assembly, keep all small parts out of the reach of children. lt may be fatal if swallowed or inhaled.
• To avoid the potential dangers of suffocation, please keep all parts and packaging (film,plastic bags, foam.etc.) away from babies and children.
• Do not stand or sit on the product.
• Never touch the product with sharp or corrosive objects.
• Please do not place overweight items on the top of this product.
• Children are not allowed to climb on or play with the product for safety reasons. as this may cause the product to tip over and result in immeasurable injury.
• Make sure all parts and screws are tightened for a stable structure before use to reduce safety hazards.

Accessories List

EXPLODED A

EXPLODED B

Please refer to STEP 1 to STEP 13

Please refer to STEP 14 to STEP 26

CONGRATULATION!!

REMOTE CONTROL

Set the LED light controlled by a specific remote

step1. Unplug the LED light and wait for a few seconds.
step2. Plug in the LED light, within 5 seconds, press and hold the “POWER” and “BRIGHT-” buttons at the same time until the LED flash white light.

The LED light strip is currently restricted to be controlled only by this remote.
However, if you press and hold the red button until the LED flash white light, it will restore the ability to be controlled by any remote.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>