70mai A810 4K Dash Cam User Manual
- June 14, 2024
- 70mai
Table of Contents
70mai A810 4K Dash Cam User Manual
Product overview
Please read this manual carefully before using the product and keep it in a
safe place.
- Display
- Function buttons
- Power button
- Microphone
- Ventilation holes
- Indicator
- Mount slot
- Camera
- Speaker
- Rear camera port
- Power port
- Memory card slot
- Adhesive sticker
Note: Illustrations of the product, accessories, and user interface in the user manual are for reference purposes only. The actual product and functions may vary due to product enhancements.
Package contents
If you purchased the dash cam only, check the following items in the package:
- Dash Cam × 1
- Mount × 1
- Power cord × 1
- Car charger × 1
- Wiring trim tool × 1
- Electrostatic sticker × 1
- User manual × 1
If you purchased the Dash Cam Set, check the following items in the package:
- Dash Cam × 1
- Mount × 1
- Power cord × 1
- Car charger × 1
- Wiring trim tool × 1
- Electrostatic sticker × 1
- User manual ×1
- Rear camera package* × 1
- This package contains the rear camera(integrated with lead wire), signal wire and other accessories for the rear camera. For more information about the rear camera, please refer to the rear camera user manual.
Installation
Installing the electrostatic sticker
Paste the electrostatic sticker on the recommended area on the front windshield. Press the sticker to remove air bubbles out.
Avoid the edge of the windshield and select the flat and smooth area for the installation.
Note: Keep windshield clean and dry without liquid residue to prevent the sticker from losing adhesion and dash cam from dropping.
Installing the mount
Attach the mount into the mount slot and slide up
Installing the memory card
Insert the memory card into the card slot.
Mounting the dash cam
Paste the dash cam onto the electrostatic sticker.
Routing cable
Route the power cord to the cigarette lighter and connect power.
Notes:
- Use the included wiring trim tool to hide the power cord underneath the vehicle’s headliner and rubber seal along the A-pillar.
- Depending on the vehicle, the cigarette lighter socket may be located in a different position. The above figure is for reference only
Adjusting the camera angle
Turn on the dash cam and adjust the camera angle based on the preview screen.
Accessories (optional)
The rear recording function of this product needs to be used with the rear
cameras. Scan the QR code to obtain the operation guide for rear camera.
Note: To avoide the rear camera malfunction due to device incompatibility, it is recommended to use a rear camera from 70mai brand.
Download 70mai app
This product may be used in conjunction with the 70mai app. You can download
and install the app by scanning the QR code or finding “70mai” in the app
store.
Note: Android 5.0 & iOS 11.0 or above is required to connect to the dash cam’s Wi-Fi hotspot with a mobile phone
Online guide
For more on product functions and FAQs, please see the user guide by scanning
the QR code.
Specifications
- Product: Dash Cam
- Model: A810, A810-2
- Input: 5V 2A
- Battery capacity: 500mAh
- Resolution: 3840 × 2160
- Lens: FOV 150°/ F1.8
- Battery type: Li-ion battery
- Power supply: Car cigarette lighter
- Wireless connectivity: Wi-Fi IEEE 802.11 b/g/n 2.4GHz, Bluetooth® 4.2
- Bluetooth/Wi-Fi operation frequency: 2400–2483.5MHz
- GPS/GLONASS operation frequency: 1559–1610MHz
- Bluetooth maximum output: < 13dBm
- Wi-Fi maximum output: < 20dBm
Memory card instructions
-
A memory card (sold separately) must be installed in the dash cam before use.
-
The dash cam supports standard MicroSD cards. Please use memory cards with the minimum capacity of 32GB and rating of U3(UHS-3) or above.
-
The default file partition format of the memory card may be inconsistent with the format supported by the dash cam. When inserting the memory card for the first time, please format it in the dash cam before use. Formatting the memory card will delete all files on the card. Please back up important data to another device beforehand.
-
The memory card may become damaged or deteriorated after repeated cycles of overwriting, and this may affect its ability to save video and image files. If this occurs, immediately replace it with a new memory card.
-
Please use a high-quality memory card purchased from a reputable vendor. Inferior memory cards may have issues such as the actual reading/writing speeds do not match the stated speeds, and the actual storage capacity does not match the stated storage capacity.
We shall not be held liable for lost or damaged videos caused by the use of a low-quality memory card. -
Do not insert or remove a memory card while the dash cam is turned on.
Precautions
Before using this dash cam, please read all the precautions and the online guide to ensure correct and safe use.
- This dash cam is intended to assist drivers with the purpose of recording the environment outside the vehicle. The dash cam does not guarantee the user’s driving safety. We shall not be held liable for any accident, damage, or loss of information caused by operating the dash cam while driving.
- Due to differences in vehicle conditions, driving style, driving environment, etc., some functions may not work properly. A power failure, usage in environments outside the normal operating temperature or humidity range, a collision, or a damaged memory card may cause the dash cam to function abnormally. There is no guarantee that this dash cam will function normally under all circumstances. Videos recorded by this dash cam are for reference only.
- Please install this dash cam correctly, and do not block the driver’s line of sight, nor block the vehicle’s airbag, in order to avoid product failure or personal injury.
- Please use the included car charger, power cord, and other accessories in order to avoid product failure due to non-conformance. We shall not be held liable for any loss or damage caused by the use of a non-genuine car charger or power cord.
- If the battery becomes deformed, swollen, or starts leaking during use or storage, stop using the dash cam immediately in order to avoid safety issues, and contact after-sales service.
- Please keep this dash cam away from any strong magnetic fields, as they may cause damage to the dash cam.
- Do not use this dash cam in environments with temperatures over 60°C or below -10°C.
- Please only use this dash cam within the scope permitted by law.
Regulatory compliance information
WEEE information
All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for more information about the location as well as terms and conditions of such collection points.
EU declaration of conformity
The manufacturer hereby, declares that this equipment is in compliance with the applicable Directives and European Norms, and amendments. The full text of the EU declaration of conformity is available at the following internet address: https://help.70mai.asia/1193.html
Hereby, 70mai Co.,Ltd. declares that the radio equipment types A810 and A810-2 are in compliance with Radio Equipment Regulations 2017. The full text of the UKCA declaration of conformity is available at the following internet address: https://help.70mai.asia/2145.html
Cautions
- Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.
- Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas.
- A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
- This device is equipped with a built-in battery that cannot be removed or replaced. Do not disassemble or modify the battery by yourself.
- Replacement of a battery with an incorrect type can defeat a safeguard (for example, in the case of some lithium battery types).
FCC
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
ISED compliance statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
ISED Radiation Exposure statement
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body.
Scan the code to view the product functions, FAQs and tutorial videos.
https://dashcam.70mai.com/support
United States
1-877-746-6088
Canada (English)
1-888-507-9088
Mon-Fri 9am-6pm PST
https://dashcam.70mai.com/support
help@70mai.com
Service: help@70mai.com
For further information, please go to www.70mai.com
Manufacturer: 70mai Co., Ltd.
Address: Room 2220, Building 2, No. 588 Zixing Road, Minhang District,
Shanghai, China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>