70mai A800S 4K Dash Camera User Manual

June 5, 2024
70mai

70mai A800S 4K Dash Camera

Product Overview

Please read this manual carefully before using the product and keep it in a safe place.

70mai-A800S-4K-Dash-Camera-1

  1. Function Buttons
  2. Indicator
  3. Display
  4. Microphone
  5. Speaker
  6. OPower Button
  7. Mounting Slot
  8. Power Port
  9. Camera
  10. Rear Camera Port
  11. Ventilation Holes
  12. Memory Card Slot

Installation

Installing the electrostatic sticker.
Clean your windshield and put the electrostatic sticl er on the recommended area as shown in the figure below. Avoid the edge of the windshield and select the flat and smooth area for the installation. Make sure you remove air bubbles between the sticker and the glass.

Installing the memory card.
Insert the memory card into the card slot with its contacts facing up until you hear a click. The memory card is well-installed.

Installing the mount.
Attach the mount into the slot and slide up, as shown in the figure below. You will hear a snap when it is in place. Make sure the mount is securely installed to the dash cam.

Mounting the dash cam.
Peel off the protective film from the adhesive sticker on the base of the mount, and paste the dash cam onto the electrostatic sticker in the dotted area.

Connecting the power supply.

As shown in the figure below, run the power cord along the top of the windshield, down the A-pillar, and around the glove compartment, so that the power connector is near the cigarette lighter. Connect the power cord to the car charger, then plug the charger into the cigarette lighter socket.

Note:

  • Use the included crowbar to hide the power cord underneath the vehicle’s headliner and rubber seal along the A-pillar.
  • Depending on the vehicle, the cigarette lighter socket may be located in a ditterent position. The above figure is for reterence only.

Adjusting the dash cam angle.
Turn on the dash cam and adjust the camera angle based on the preview screen to ensure that the camera is facing the front of the vehicle.

Accessories (optional)

The rear recording function of this product needs to be used with the rear cameras. Scan the QR code below to obtain the operation guide for rear camera.

Note: To avoide the rear camera malfunction due to device incompatibility, it is recommended to use a rear camera from 70mai brand.

Download 70mai App

This product may be used in conjunction with the 70mai App. Please search for “70mai” in the App Store or scan the following QR code to download and install the App.

Note: Android 4.4 & iOS 9.0 or above is required to connect to the dash cam’s Wi-Fi hotspot with a mobile phone.

Online Guide
Scan the below QR code to access the online guide. The guide provides detailed product information including descriptions of functions. Please carefully read this guide before use in order to avoid damage due to in correct use.

Packing list

  1. 70mai Dash Cam A800S X1
  2. Mount X1
  3. Power Cord X1
  4. Dual USB Car Chargerx1
  5. Wiring CrowbarX 1
  6. Electrostatic Sticker X 2
  7. Adhesive Sticker X 2 (with 1 pre-applied to the mount)
  8. User ManualX1

Memory Card Instructions

  • Amemory card (sold separately) must be installed in the dash cam before use.
  • The dash cam supports standard MicroSD cards. Please use memory cards with the minimum capacity of 32 GB and rating of U1(UHS-1) or above.
  • The default file partition format of the memory card may be inconsistent with the format supported by the dash cam. When inserting the memory card tor the first time, please format it in the dash came betore use. Formatting the memory card will delete all tiles on the card. Please back up important data to another device beforehand.
  • The memory card may become damaged or deteriorated after repeated cycles of Overwriting, and this may aftect its ability to save video and image tiles. If this occurs, immediately replace it with a new memory card.
  • Please use a high-quality memory card purchased from a reputable vendor. Inferior memory cards may have issues such as actual reading/writing speeds that do not match the stated speeds, and an actual storage capacity that does not match the stated storage capacity. We shall not be held liable for lost or damaged
  • Videos caused by the use of a low-quality memory card.
  • In order to avoid reading and writing speeds decreasing after prolonged use, it is recommended to format the memory card in the dash cam every two weeks.
  • Do not insert or remove a memory card while the dash cam is turned on.

Precautions

Before using this dash cam, please read all the precautions and the online guide to ensure correct and safe use.

  • This dash cam is intended to assist drivers with the purpose of recording the environment outside the vehicle.
  • The dash cam does not guarantee the user’s driving safety. We shall not be held liable for any accident, damage, or loss of information caused by operating the dash cam while driving.
  • Due to difterences in vehicle conditions, driving style, driving environment, etc., Some functions may not work properly. A power tailure, usage in environments outside the normal operating temperature or humidity range, a collision, or a damaged memory card may cause the dash cam to tunction abnormally. There is no guarantee that this dash cam will function normally under all circumstances. Videos recorded by this dash cam are for reference only.
  • Please install this dash cam correctly, and do not block the driver’s line of sight, nor block the vehicle’s airbag, in order to avoid product failure or personal injury.
  • Please use the included car charger, power cord, and other accessories in order to avoid product failure due to non-conformance. We shall not be held liable for any loss or damage caused by the use of a non-genuine car charger or power cord.
  • lt the battery becomes detormed, swollen, or starts leaking during use or storage, stop using the dash camm immediately in order to avoid safety issues, and contact after-sales service.
  • Please keep this dash cam away from any strong magnetic fields, as they may cause damage to the dash cam.
  • Do not use this dash cam in environments with temperatures over 60°C or below -10°C.
  • Please only use this dash cam within the scope permitted by law.

FCC

Changes or modifications not expressly approved by the party responsible for compliance could void the user authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interterence to ra interterence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment offt and on, the user is encouraged to try to correct the interterence by one or more of the following measures:

  • Reorientor relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit difterent trom that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

communications. However, there is no guarantee This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interterence, and (2) this device must accept any interterence received, including interterence that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth tor an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Regulatory Compliance Information

WEEE Information
All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment toa designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for more information about the location as well as terms and conditions of such collection points.

EU Declaration of Conformity
CE The manufacturer hereby, declares that this equipment is in compliance with the applica ble Directives and European Norms, and amendments. The full text of the EU declaration of conformity is available at the following internet address: https://help.70mai.asia/1193. html

Safety information

Caution
Battery abuse or mishandling can cause overheat, liquid leakage, or an explosion. To avoid possible injury, do the following:

  • Do not open, disassemble, or service any battery.
  • Do not attempt to replace the internal rechargeable lithium batteries.
  • Do not crush or puncture the battery.
  • Do not short-circuit the battery, or expose it to water or other liquids.
  • Keep the battery away trom children.
  • Keep the battery away trom fire.
  • Do not leave the battery in an extremely high-temperature environment or an extremely low air pressure environment.
  • Stop using the battery it it is damaged, or it you notice any discharge or the buildup of foreign materials on the battery leads. We recommend that the batteries be charged about once every three months to prevent overcharge.
  • Do not put the battery in trash that is disposed of in landfills. When disposing of the battery, comply with local laws or regulations. Service: help@7Omai.com

For further information, please go to www.7omai.com Manufacturer: 70mai Co., Ltd. Address: Room2220, building2, No.588, Zixingroad, MinHangDistrict, Shanghai, China

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals