70mai X200 Omni Dash Cam User Manual

: October 30, 2023
: 70mai

Table of Contents

70mai X200 Omni Dash Cam
Product Overview
Specifications
Packaging List
Installation
Downloading 70mai app
Precautions
Warranty Conditions
EU Declaration of Conformity
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

70mai X200 Omni Dash Cam

70mai-X200-Omni-Dash-Cam-PRODUCT

Product Overview

The 70mai Dash Cam Omni is a device that captures footage of your car’s surroundings while you drive. It has a display screen, camera, microphone, and speaker. The dash cam comes with a mount that can be attached to your car’s windshield using an adhesive sticker. The product also comes with a power cord, car charger, and user manual. Please read this manual carefully before using the product and keep it in a safe place.

70mai-X200-Omni-Dash-Cam-FIG-1

Power button
Upper button
Lower button
Adhesive sticker
Mount
Microphone
Display screen
Camera
Speaker
Power port
Round-shape indicator
Tripod head

Specifications

Product : Dash Camp
Model : 70mai Dash Cam Omni
Resolution : Not specified
Lens : Not specified
Battery capacity : Not specified
Input: Not specified
Power supply : Car charger
Battery type : Not specified

Packaging List

Dash Cam x 1
Power cord x 1
Car charger x 1
Mount (Pre-installed on the dash cam) x 1
Electrostatic sticker x 1
Wiring crowbar x 1
Adhesive sticker x 2 (With 1 piece pre-applied to the mount)
User manual x 1

Installation

Selecting Mounting Position

The dash cam can be mounted on either of the recommended positions of the front windshield as appropriate:

Near the center of rearview mirror
On the front of the passenger seat

Make sure the camera is below the level line of the rear-view mirror. Attach the electrostatic sticker on the selected position, with the gap image facing upwards. Press the sticker to remove air bubbles out. Keep windshield clean and dry without liquids residue to prevent the sticker from losing adhesion and dash cam from dropping.

Installing the Dash Cam
Paste the dash cam on the electrostatic sticker. Make sure the gap on the adhesive sticker aligns with that on the electrostatic sticker and the display screen faces the car interior.

Routing Cable
Route the power cord to the cigarette lighter and connect power. Use the included crowbar to hide the power cord underneath the vehicle’s headliner and rubber seal along the A-pillar. Depending on the vehicle, the cigarette lighter socket may be located in a different position.

Notes:

Use the included crowbar to hide the power cord underneath the vehicle’s headliner and rubber seal along the A-pillar.
Depending on the vehicle, the cigarette lighter socket be located in a different position. The figure provided is for reference only.

Adjusting Dash Cam Angle
Hold the dash cam and turn it up and down to adjust the angle based on the preview screen.

Installing/Uninstalling the Mount
The mount is pre-installed on the dash cam. If you need to uninstall it, follow these steps:

Uninstalling the mount: Hold the dash cam and screw it clockwise and then the dash cam will separate from the mount.
Installing the mount:
Align the microphone with the big locating point on the right of the mount, and then insert the dash cam into the mount.
Hold the dash cam and screw counter clockwise until the microphone is aligned with the big locating point on the left of the mount, and then tighten up with the mount.

Downloading 70mai app

This product needs to be used conjunction with the 70mai app. You can download and install the app by scanning the QR code or finding “70mai” in the app store.

Note : Android 4.4 & iOS 9.0 or above is required to connect to the dash cam’s Wi-Fi hotspot with a mobile phone

User guide
For more on product functions and FAWs, please set the user guide by scanning the QR code.

Accessories (optional)
This product can also be used with the 70mai 4G Hardwire Kit. Scan the QR code to obtain the user guide for the 70mai 4G Hardwire Kit

Precautions

Before using the dash cam, please read all the precautions and the user guide to ensure correct and safe use.

The das cam is intended to assist drivers with the purpose of recording the environment outside the vehicle. The dash cam does not guarantee the user’s driving safety. We shall not be held liable for any accident, damage, or loss of information caused by operating the dash cam while driving.
Due to difference in vehicle conditions, driving style, driving environment, etc., some functions may not work properly. A power failure, usage in environments outside the normal operating temperature or humidity range, or a collision may cause the dash cam to function abnormally. There is no guarantee that this dash cam will function normally under all circumstance. Videos recorded by this dash cam are for reference only.
The eMMC (Embedded Multi Media Card) is built in the dahs cam for storage. You can find the memory capacity information on the label of the dash cam and product box.
Install the dash cam correctly, and do not block the driver’s line of sight, nor block the vehicle’s airbag, in order to avoid product failure or personal injury.
Use the included car charger, power cord, and other accessories in order to avoid product failure due to non-conformance. We shall not be held liable for any loss or damage caused by the use of non-genuine car charger or power cord.
The dash cam is equipped with a built-in battery that cannot be removed. Do not disassemble the dash cam. Do not expose batteries or battery packs to sunlight, fur, or environments where the ambient temperature is extreme heat. There is a risk of explosion if the battery is incorrectly installed, therefore only used and replace with the same or an equivalent type of battery.
Keep the dash cam away from water drops or splashes.
Keep the device dry to avoid battery failure.
If the battery becomes deformed, swollen, or starts leaking during use or storage, stop using the dash cam immediately in order to avoid safety issues, and contact after-sales service.
Never wash the dash cam with chemical solvent or cleaner.
Keep the dash cam away from any strong magnetic fields, as they my cause damage to the dash cam.
Do not use the dash cam in environments with temperatures over 60°C or below -10°C.
After working for a period of time, the case temperature of the dash cam will rise, please be careful when touching it.
Only use this dash cam within the scope permitted by law.

Cautions

Dispose of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.
Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage or flammable liquid or gas.
This device is equipped with a built-in battery that cannot be removed or replaced. Do not disassemble or modify the battery by yourself.
Replacement of a battery with a incorrect type can defeat a safeguard (for example, in the case of some lithium battery types).

Warranty Conditions

A new product purchased in the Alza.cz sales network is guaranteed for 2 years. If you need repair or other services during the warranty period, contact the product seller directly, you must provide the original proof of purchase with the date of purchase.
The following are considered to be a conflict with the warranty conditions, for which the claimed claim may not be recognized:

Using the product for any purpose other than that for which the product is intended or failing to follow the instructions for maintenance, operation, and service of the product.
Damage to the product by a natural disaster, the intervention of an unauthorized person or mechanically through the fault of the buyer (e.g., during transport, cleaning by inappropriate means, etc.).
Natural wear and aging of consumables or components during use (such as batteries, etc.).
Exposure to adverse external influences, such as sunlight and other radiation or electromagnetic fields, fluid intrusion, object intrusion, mains overvoltage, electrostatic discharge voltage (including lightning), faulty supply or input voltage and inappropriate polarity of this voltage, chemical processes such as used power supplies, etc.
If anyone has made modifications, modifications, alterations to the design or adaptation to change or extend the functions of the product compared to the purchased design or use of non-original components.

EU Declaration of Conformity

Identification data of the manufacturer’s / importer’s authorized representative:

Importer : Alza.cz a.s.
Registered office : Jankovcova 1522/53, Holešovice, 170 00 Prague 7
CIN : 27082440

The manufacturer hereby, declares that this equipment is in compliance with the applicable Directives and European Norms, and amendments. The fill text of the EU declaration of conformity is available at the following internet address: https://help.70mai.asia./1993.html

WEEE
This product must not be disposed of as normal household waste in accordance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE – 2012/19 / EU). Instead, it shall be returned to the place of purchase or handed over to a public collection point for the recyclable waste. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. Contact your local authority or the nearest collection point for further details. Improper disposal of this type of waste may result in fines in accordance with national regulations.

Dear customer, Thank you for purchasing our product. Please read the following instructions carefully before first use and keep this user manual for future reference. Pay particular attention to the safety instructions. If you have any questions or comments about the device, please contact the customer line.