Rebel RB-2001-CH Battery Charger User Manual
- June 15, 2024
- Rebel
Table of Contents
Rebel RB-2001-CH Battery Charger
Safety instructions for chargers
Read the below instructions for charger use and care carefully. Improper use
may result in the risk of fire, electric shock and/or serious injuries.
Producer does not take responsibility for damages caused by inappropriate
handling and use of the product.
- Do not attempt to open or disassemble the charger. If the charger has been dropped or is damaged in any way, stop using it and do not attempt to repair it. Return the charger for repair to an authorized service center or a qualified person, to avoid any danger to the user; or discard it according to local laws.
- Protect the charger against any heat source (e.g. direct sunlight exposure, fire, heater) to prevent any damage to the charger.
- Do not expose the charger to water, moisture and cold. Risk of electric shock.
- If the power cord or the plug becomes damaged, stop suing the charger until it has been repaired by a qualified person. If the supply cord is damaged, it must be replaced by the manufacturer or its authorized service center, in order to avoid a hazard. Risk of electric shock.
- Only use the charger provided with the tool, or a same type or same model charger to charge the battery. The use of other types of charger increases the risk of electric shock, personal injury and damage.
- Never attempt to recharge non-rechargeable batteries. Explosion hazard.
- Only use the charger at ambient temperatures between +10°C and +40°C. Store charger in a dry location protected from cold where temperature would not exceed +40°C.
- The charger is intended for indoor use only. Place charger on solid, flat non-flammable surface and away from any flammable materials when re-charging the battery pack.
- Do not recharge the battery pack in a wet or humid environment.
The charger and battery pack may heat during charging process.
Charging
- Place the AC charger on a flat and stable surface within about 1 meter from the power supply socket.
- Remove the battery from the power tool. Press and hold the battery release button and slide out the battery at the same time.
- Slide the battery to the AC charger maximally so that it locks in place.
- Connect the AC charger to the power supply socket.
- When the battery is fully charged, slide it out from the AC charger and slide it in the power tool so that it locks in place.
Charging indicators
The AC charger has charging indication lights which indicate the status of the charging process:
| LED | Status |
|---|---|
| Red | Battery charging in progress |
| Green | Battery charging finished, battery fully charged |
- It takes about 1,5 hour to fully charge the power tool.
- AC charger and battery may heat up during charging. It is a normal behavior
English
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.
Made in China for Lechpol Electronics Leszek Sp.k., ul. Garwolińska 1, 08-400 Miętne.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>