SPECTROLINE SPN-VIN365 Vintage 365 Handheld Inspection Lamp Instruction Manual

SPECTROLINE SPN-VIN365 Vintage 365 Handheld Inspection Lamp Instruction

Product Information

cm) x 5 inches (12.7
cm)
Light Source| 2 UV-A LEDs
Cord Length| 8 Ft. (2.4 m)
Electrical Specifications| Input: 100 – 240V, 50/60Hz
Output: 7 – 12V DC 500mAProduct Usage Instructions

Ensure eye and skin protection when using the product, as it emits UV radiation.
This product is intended for professional examination use only.
To disassemble the Filter Protector for maintenance, follow these steps:

1. Remove the front rubber cover/filter holder by peeling it toward the front portion of the lamp.
2. Clean the glass filter as needed.

Replacement Parts

WARNING
UV emitted from this product. Avoid eye and skin exposure to unshielded products. FOR PROFESSIONAL EXAMINATION USE ONLY

IMPORTANT SAFETY INSTRUCTIONS

(Read all instructions)

• Do not operate the Vintage™ 365 UV-A LED NDT Inspection Lamp (SPN-VIN365) with a damaged cord or if the lamp has been physically damaged.
• Do not look directly into the light. ALWAYS wear the UV-absorbing protective glasses provided when operating the lamp. Use in low-light conditions to achieve the best inspection results. The darker the room, the greater the fluorescent contrast.
• The Vintage™ 365 is not approved for use in hazardous atmospheres. Do not attempt to use it in areas requiring explosion-proof lighting.
• Never use this equipment in any manner not specified in these instructions because your protection may be impaired.
• NEVER aim the lamp in the direction of another human being. It is meant for professional fluorescent inspections ONLY!
• DO NOT attempt to modify the lens assembly or light output. Doing so may alter the performance and intensity of the Vintage™ 365.

VINTAGE™ 365 OPERATION

• The Vintage™ 365 is shipped factory-set at the specified intensity for optimal perfor-mance during inspections.
• Carefully unpack and inspect the lamp for possible damage during shipment. If any damage is noted, immediately notify the carrier and supplier before attempting to use the lamp.
• The Vintage™ 365 has a two-position rocker power switch (I–UV; O–off) on the han-dle. Prior to using the unit, ensure that the button is in the OFF position (no light illuminating from the lamp). Press the button once to turn the lamp on. Instant-on operation ensures that the UV-A LED will reach full intensity very quickly. Check to see if the unit is operating optimally. Press it again to turn the lamp off

DISASSEMBLING THE FILTER PROTECTOR FOR MAINTENANCE

The outer rubber cover/filter holder may be removed periodically to clean the glass filter. To disassemble the Filter Protector, first remove the front rubber cover/filter holder. Peel the rubber cover/filter holder toward the front portion of the lamp

The glass filter will remain inside the protector. To remove the glass filter, peel around the edge of the rubber cover/filter holder and push the glass filter out. To replace or reinsert the glass filter into the rubber cover/filter holder, slide the glass filter into the channel of the rubber cover/filter holder. Manipulate the rubber cover around the filter. Ensure the glass filter is evenly seated.

REPLACING THE UV LENSES
The UV-A lenses covering the UV-A LEDs must be replaced over time. They will solarize (become cloudy and yellow) from repeated use. A set of detailed instructions come with the replacement UV-A lenses. See the Replacement Parts section and contact Customer Service for more details.

ENVIRONMENTAL SPECIFICATIONS

The Vintage™ 365 series lamps are designed to be safe under the following conditions:

• For Indoor Use;
• Temperature 41°F to 122°F (5°C to 50°C);
• Mains supply voltage fluctuations not to exceed ±10% of the nominal voltage.

LIMITED WARRANTY

The warranty policy for the Vintage™ 365 lamp is provided on the Certificate of Limited Warranty enclosed separately with each unit. NOTE: For assistance of any kind, please contact the Customer Service Department at Spectro-UV. Provide the model, the serial number of the unit, and the date of purchase.

NOTE : Be sure to use genuine Vintage™ 365 replacement parts. Using another manufacturer’s replacement parts could affect product performance and will void the warranty.

MEASURING LAMP INTENSITY
To ensure that your Vintage™ 365 series lamp is operating at the required UV intensity, it should be checked periodically. Spectro-UV offers a variety of sensors and meters. The AccuPRO™ XP-2000 combines the functionality of a UV and visible light radiometer/photometer and is specially designed to measure UV irradiance with wavelengths of 320–400nm (with peak at 365nm) and visible light from 460–675nm (with peak at 555nm). Other suitable meters include the AccuMAX™ XRP-3000 radiometer/photometer kit, using dual-wavelength UV-A and VIS sensor detectors to accurately measure the irradiance of a light source. The AccuMAX™ XR-1000 digital readout unit with the XS-365 UV sensor or the DM- 365XA digital readout unit can also be used for UV-A measurement. For more information about these units, please contact the Customer Service Department at Spectro-UV. In the Call toll-free at 1-866-230-7305.

SPN-VIN365 Technical Details

KEY FEATURES

• Nominal steady-state intensity of 5,500 µW/cm2 (+/- 500 µW/cm2) at 15 inches (38cm
• Less than 1.0 foot-candle (11 lux) emission.
• Area of coverage: minimum 1,200uW/cm2 over an 8” diameter at 15 inches
• Long-lasting UV-A lenses.
• Cool running, fanless design.
• Lightweight and rugged construction.
• Meets EN ISO 3059 standards for non-destructive testing.

TECHNICAL SPECIFICATIONS

SPN-VIN365

• Height 9.5 inches (24.1 cm)
• Length 7.1 inches (18 cm)
• Width 5 inches (12.7 cm)
• Weight 2.1 lb. (953 g)
• Light Source 2 UV-A LEDs
• Cord Length 8 Ft. (2.4 m)

ELECTRICAL SPECIFICATIONS

• Input: 100 – 240V, 50/60Hz (depending on lamp model and power plug)
• Output : 7 – 12V DC 500mA

LAMP MODELS AND VOLTAGES

SPN-VIN365 Replacement Parts

www.Spectro-UV.com
4 Dubon Ct., Farmingdale, NY 11735
866-230-7305

References

• Spectro-UV:Blacklight, Ultraviolet & Non Destructive Testing Equipment

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>