FALCON W101H613 W Series Passage Hana Knob Lock User Guide
- June 13, 2024
- Falcon
Table of Contents
FALCON W101H613 W Series Passage Hana Knob Lock
Installation Instructions
For Installation
For Door Preparation
Standard Core
- A. Outside Knob
- B. Knob Collar
- C. Cylinder and Tailpiece
- D. Rose and Adjustment Plate
- E. Cylinder Sleeve
- F. Chassis
- G. Inside Mounting Plate
- H. Mounting Screws (2)
- J. Inside Rose
- K. Inside Knob
- L. Latch
- M. Strike
- N. Latch Screws (2)
- P. Strike Screws (2)
- Q. Pin Wrench
Install Lock
Use Template to Check Door Holes
Note: If door holes do not match template, see DOOR PREP section.
Customer Service
Install Latch
For 7/s” (22 mm) hole, remove sleeve
If Needed, Adjust Rose
Chassis is factory set for 1¾” (44 mm) door
For 13/a” (35 mm) thick door
- Rotate rose until it stops
- Nine 360° rotations
For 1¾” (44 mm) thick door
- Rotate rose until it stops
- Nine 360° rotations
Install Outside Chassis Assembly
If Needed, Install Cylinder
Standard Core
- Rotate key while inserting
Install Inside Mounting Plate
Install Inside Rose
Install Inside Knob
Install Strike
Check SFIC Knob Orientation
- Rotate knob to reveal catch inside hole
Door Preparation
Determine Bevel
Mark Centerline and Drill Points
Drill Holes
NOTE: Drill from both sides to avoid splintering wood
Mortise Cutout for Latch
Drill Holes for Strike
Mortise for Strike
DIMENSION
Additional Notes
- None
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>