SEBSON MIRROR_CAB_6W 60cm LED Mirror Lamp Instruction Manual
- June 13, 2024
- SEBSON
Table of Contents
MIRROR_CAB_6W
Manual
Thank you for choosing a product of SEBSON. Read the instructions carefully and keep them for looking up before start-up this product. A long and failure- free operation can only be guaranteed if the installation and start-up is done properly. Before starting up this product, please check for external damage. In case of visible external damage we immediately dis-advise the start-up of this product! Please remove all packaging material of this product before the first start-up an and check the content for completeness!
Intended use:
This lamp of the brand SEBSON can be mounted on different furniture like
cupboards, shelves or even on the wall.
Scope of delivery:
- 1 Light
- 2 Screws for fixing
- 1 12V power plug
General safety information:
Danger: In case of damages or contact with water turn off this product
immediately without tension and make sure
that a restart is no longer possible!
Danger of suffocation: Keep this product away from children and animals!
The packaging contains small parts that can be swallowed!
Caution: Set up the light beam of the light never directly at people or animals to prevent fire damage or eyes damage and avoid looking directly into the light source!
- An exchange of the built-in luminous in the light is not possible!
- The remodeling of this product is not allowed! The proper and safe functioning of the device can no longer be guaranteed if it is modified! In addition, this will invalidate the warranty claim!
- Do not connect a dimmer as this may cause a damage to the lamp. As a result of a strong heat development the LED can be damaged!
- Do not cover the light with heat insulating materials! As a result of a strong heat development the LED can be damaged!
- The manufacture does not accept any responsibility for injuries or damage resulting from improper use of this product!
- Any other use than the description may result in damage to the product. So the dangers are such as electric shock, short circuit, fire etc.
- We reserve the right to make changes to the product, the packaging or the operating instructions as well as printing errors.
- Protect the product from external damage, heavy dirt, moisture and excessive heat!
- In order that the warranty claim does not expire please use only the supplied items. Repairs may only be done by an expert and only by using original spare parts!
- In commercial institutions, the accident prevention regulations of the professional trade association for electrical equipment and facilities must be adhered to.
Notes on commissioning:
Caution: Do not put the product into operation until all cables are connected together! Make sure that the mains voltage of your house line corresponds to the specifications in the “Technical Data”!
- This product is only suited for indoor-use and not for outdoor-use!
- For mounting the lamp, choose a stable mounting surface that can support the weight of the lamp. The manufacturer is not liable for damage caused by the use of an unsuitable mounting surface!
- Install the lamp on a dry and non-conductive surface!
- This product is suitable for mounting on normally flammable surfaces!
- Plan a minimum distance of 50cm between the illuminated area and the lamp.
- To prevent damage to the cables, they must not be strongly bent, pulled or twisted during commissioning!
Technical Data:
Operating voltage:|
12V DC
---|---
Nominal wattage:|
6W
Nominal luminous flux:|
450lm
Rated color temperature:|
4.000K
Electrical protection:|
IP20
Protection class:|
III
This product contains a light source of energy efficiency class G.
Information for private households (WEEE):
The Electrical and Electronic Equipment Act (WEEE) contains a large number of requirements for the handling of electrical and electronic equipment. The most important ones are summarised here.
1. Separate collection of waste equipment
Old, worn-out or defective electrical and electronic equipment is referred to
as waste equipment. These devices must not be disposed of in the normal
household waste or together with the residual waste. The devices should be
transferred to special collection and return systems.
2. Batteries and rechargeable batteries as well as illuminants
As a rule, owners of WEEE shall separate spent batteries and accumulators that
are not enclosed in the WEEE, as well as light sources that can be removed
from the WEEE without causing damage, from the WEEE before handing it over to
a collection point. This does not apply if WEEE is prepared for reuse with the
participation of a public waste management authority.
Batteries or rechargeable batteries that contain harmful substances are marked
with the symbol of a crossed-out dustbin and must not be disposed of in
household waste. Below the dustbin symbol is the chemical name of the
pollutant – in the example below “Cd” for cadmium. “Pb” stands for lead, “Hg”
for mercury:
If disposed of improperly, the substances contained in the batteries may cause
hazards to health and the environment. The hazards are averted by the separate
collection and proper disposal of used batteries.
3. Options for returning old appliances
Owners of WEEE from private households can hand it in free of charge at the
collection points of the public waste management authorities or at the take-
back points set up by manufacturers or distributors.
4. Data privacy notice
Old devices often contain sensitive personal data. This applies in particular
to information and telecommunications technology devices such as computers and
smartphones. In your own interest, please note that each end user is
responsible for deleting the data on the end-of-life devices to be disposed
of.
5. Meaning of the “crossed-out dustbin” symbol
The symbol of a crossed-out dustbin regularly displayed on electrical and
electronic equipment indicates that the respective device must be collected
separately from unsorted municipal waste at the end of its service life.
Cleaning:
Danger : Before cleaning, disconnect the product from the power supply by
pulling the power plug out of the socket!
Use a slightly moistened cloth for cleaning. In order not to damage the
product, it is essential to avoid water penetrating into the housing! Never
clean the device under running water! Do not use solvent-containing cleaner
for cleaning. Do not use solvent-containing cleaner for cleaning!
SEBSON
Sebastian Sonntag
Walter-Behrendt-Str.10
44329 Dortmund
Germany
support@sebson.de
VAT-Nr.: GB179436663
WEEE-Reg.-ID.: 500617
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>