My PowerForce®/PowerGroom® Bagged Vacuum is loud | Support

• Unplug the machine

  • Remove the bag door cover

  • Slide out the Pre-Motor Filter located below the vacuum bag and clean with warm water

    • Let air dry completely (24-48 hrs.) before placing back in machine

  • Remove the Post Motor filter on side of machine and tap against a waste bin to remove any debris

  • Dirty filters could damage the motor and cause it to sound loud

  • Remove the Brush Access Plate by unscrewing the 4 screws on the bottom

    • There are 2 screws in front and 2 behind the brush

  • Remove the Brush Access Plate to access the brush and belt

  • Inspect the brush and belt and replace if either are damaged

    • The brush should spin freely by hand
    • To test the brush, stand brush up on table and swipe hand across bristles
    • If turns freely, brush is ok
    • If brush doesn’t turn, replacement brush will need to be ordered
    • The belt should be fully intact
    • If the brush does not spin freely, it may create noise as the belt tries to spin the brush

  • Remove the brush and belt from the machine and turn on the vacuum

    • If the noise is gone, a new brush will be needed

  • If the noise is still present, please visit a BISSELL Authorized Service Center or Contact Us

  • Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>