protech TL4582 High Temperature PLA ABS 3D Pen Kit User Manual
- June 4, 2024
- protech
Table of Contents
protech TL4582 High Temperature PLA ABS 3D Pen Kit
FUNCTIONS
OPERATING INSTRUCTIONS
- Plug in the AC adapter or to a power bank that has an output of 2A or above.
- Click the filament loading button once to start heating. When the actual temperature reaches the preset temperature, the pen is ready to work.
- Put the filament in through the filament loading hole. Keep pressing or double-clicking the filament loading button to load the filament.
- The buttons marked as “+” and “-” are used for temperature adjustment. The scope is 130ºC to 230ºC. The slide button is used for speed adjustment. Up is faster and down is slower.
- Keep pressing or double-clicking the filament unload button to unload the filament. Clicking the “+” and filament unloading button at the same time enables you to switch the temperature to fit either ABS or PLA.
- The pen will enter standby mode after 2 minutes of no operation. Click the filament loading button to start heating the pen. Please do not touch the tip of the pen.
WARNING
- This pen is suitable for children over 8 years old and adults.
- Children are only allowed to use the pen under adult supervision.
- The nozzle operates at high temperature, do not touch it while in operation.
- It is strictly prohibited to use any other material into the filament loading hole.
- Do not use power adapters other than the one provided in the kit.
- Prohibited to use filament provided by other company, with different filament parameters.
- Keep the pen away from water.
- Keep the pen in a safe place, out of reach of children.
PACKAGE CONTENTS
- AC/DC Adapter
- Filaments
- User Manual
- 3D Pen
- Plastic Screw Driver (for adjusting temperature and opening the back cover)
FILAMENT CUT
SPECIFICATIONS
- Discharging mode: Hot melt extrusion molding
- Molding: Three-dimensional molding
- Print Range: Unlimited
- Feeding Speed: Adjustable
- Printing Material: PLA/ABS
- Electric Parameter: DC5V 2A 10W
- Nozzle Diameter: 0.7mm
- Filament Diameter: 1.75mm
- Filament Temperature: ABS 220ºC, PLA 190ºC
- Power Adapter: 100-240V 50/60Hz 0.5A
- Pen Dimensions: 175mm x 17mm x 20mm
- Pen Net Weight: 46g
Distributed by
- Electus Distribution Pty. Ltd.
- Address: 320 Victoria Rd, Rydalmere NSW 2116 Australia
- www.electusdistribution.com.au
- Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>